Trim on 42-124

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Trim on 42-124

Chris Drumma
Member

Posts: 103
Threads: 48
Joined: Nov 2005
City: Freehold, NY

12-06-2006, 11:20 AM

Ron,
Yes that is the set. I have recapped it and am ready to try it. I thought that it was tennite and am glad it is wood. Will have to check out lowes for the wood.

Chuck,
No problem I also need the tennite dial surround. I have two sets that have badly damaged ones. I e-mailed larry but no response yet Icon_cry

thanks guys,
Chris

Find

« Next Oldest | Next Newest »

Messages In This Thread

Trim on 42-124 - by Chris Drumma - 12-03-2006, 08:22 AM

[No subject] - by Carl Travis - 12-03-2006, 09:50 PM

[No subject] - by Chuck Schwark - 12-04-2006, 10:04 AM

[No subject] - by Chris Drumma - 12-04-2006, 11:36 AM

[No subject] - by Ron Ramirez - 12-06-2006, 10:40 AM

[No subject] - by Chuck Schwark - 12-06-2006, 11:03 AM

[No subject] - by Chris Drumma - 12-06-2006, 11:20 AM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

Who's Online
There are currently no members online.

Login
Username:
Password:	Lost Password?
	Remember me