Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Old Russian / Soviet tube radios
#3

Well, yes, all the radios, even those built in 70s, had 110/220V switch since there were still some nooks even in 70s.

Before the WWII most places were 110-127V.

Americans did consult the largest hydroelectric plants' projects in 20s. The famous DneproGES (Dnieper Hydroelectric Plant, now in Ukraine) was consulted by Hugh Cooper.

http://en.wikipedia.org/wiki/Dnieper_Hyd...ic_Station
http://en.wikipedia.org/wiki/Hugh_Cooper

When I was growing up, I saw in 70s last 110-127V strongholds disappear, but even in 80s one could see all electronic and electrical equipment having switches for 127V (even electric shavers).


As for the vacation, if you indeed plan go there (not just for radios), sure, this may be your best bet to pick up some good equipment.

Daugava was built at A. Popov Riga Radio factory (Latvia).


Messages In This Thread
Old Russian / Soviet tube radios - by morzh - 04-19-2012, 12:56 PM
RE: Old Russian / Soviet tube radios - by Arran - 04-19-2012, 11:30 PM
RE: Old Russian / Soviet tube radios - by morzh - 04-20-2012, 11:45 AM
RE: Old Russian / Soviet tube radios - by Arran - 04-20-2012, 10:14 PM
RE: Old Russian / Soviet tube radios - by morzh - 04-20-2012, 07:35 PM
RE: Old Russian / Soviet tube radios - by morzh - 04-21-2012, 12:51 PM
RE: Old Russian / Soviet tube radios - by morzh - 04-21-2012, 01:30 PM
RE: Old Russian / Soviet tube radios - by Arran - 04-21-2012, 10:05 PM
RE: Old Russian / Soviet tube radios - by Arran - 04-21-2012, 09:26 PM
RE: Old Russian / Soviet tube radios - by morzh - 04-21-2012, 01:21 PM
RE: Old Russian / Soviet tube radios - by morzh - 04-22-2012, 02:29 PM
RE: Old Russian / Soviet tube radios - by Arran - 04-22-2012, 10:00 PM
RE: Old Russian / Soviet tube radios - by morzh - 04-23-2012, 11:16 AM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Correct model 84 Ac plug an cord type
From what I read Philco went to using brown rubber power cords in 1936, so cloth was used in the 1935 and earlier models...Arran — 11:25 PM
Correct model 84 Ac plug an cord type
Hi Bruce, I have not worked on an 84, but in general, power cords for almost any radio prior to 1938 was cloth covered...MrFixr55 — 08:34 PM
Restoring Philco 38-14
OK, well, so after staring at the sch again, I realized the problem had to be the #12/12A padder. I put a scope on the o...morzh — 08:15 PM
Correct model 84 Ac plug an cord type
Hello Bruce, I mostly use brown far as my cloth powercords go ! Here is the plug that I have used bakelite Acorn style...radiorich — 08:05 PM
Correct model 84 Ac plug an cord type
Looking for as correct as can find the right Ac plug an the correct colored cloth line. Ive seen many old photos but mos...Bruce — 04:13 PM
Restoring Philco 38-14
Rod Two Y-caps make sense if you use them from L/N to the chassis; this is only makes sense in the transformer radios...morzh — 10:11 AM
Restoring Philco 38-14
Mike, I'm curious about a specific use of he Y cap. Lately I've seen a single cap across the power transformer primary. ...RodB — 09:01 AM
Restoring Philco 38-14
hello morzh , That sounds like a plan ! Sincerely Richardradiorich — 07:45 AM
Restoring Philco 38-14
Richard, It helped some, but I still had the whining when engaging the rear power strip (I did not realize it was fro...morzh — 07:07 AM
Restoring Philco 38-14
Hello morzh, Yes , that dreaded hum in my room where i do alighment I have my cable modem and router plus desktop plus ...radiorich — 11:25 PM

[-]
Who's Online
There are currently 3472 online users. [Complete List]
» 1 Member(s) | 3471 Guest(s)
Avatar

>