1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco 37-361
Ron Ramirez
Silent Key
*****
Posts: 13,776
Threads: 580
Joined: Sep 2005
City: Ferdinand State, Province, Country: Indiana
#22

04-29-2012, 02:06 PM
How did you connect (20)? No, it should not be hot at all. It sounds like you may have (20) backwards? That would not only cause the hum, but if connected backwards, that cap would not only get hot, it will explode sooner or later.

The positive lead goes to the junction of resistors (13), ( 18 ) and (19) plus a couple other connections - see schematic; the negative lead goes to chassis ground. If it has been connected backwards, it is ruined and must be replaced.
--
Ron Ramirez
Ferdinand IN
Find
« Next Oldest | Next Newest »


Messages In This Thread
Philco 37-161 - by cmhsr - 04-20-2012, 03:49 PM
RE: Philco 37-161 - by Ron Ramirez - 04-20-2012, 07:52 PM
RE: Philco 37-161 - by cmhsr - 04-20-2012, 07:54 PM
RE: Philco 37-161 - by Ron Ramirez - 04-20-2012, 07:56 PM
RE: Philco 37-361 - by Ron Ramirez - 04-23-2012, 08:35 PM
RE: Philco 37-361 - by cmhsr - 04-23-2012, 09:13 PM
RE: Philco 37-361 - by Ron Ramirez - 04-24-2012, 05:26 AM
RE: Philco 37-361 - by cmhsr - 04-24-2012, 08:21 AM
RE: Philco 37-361 - by Ron Ramirez - 04-24-2012, 08:34 AM
RE: Philco 37-361 - by cmhsr - 04-24-2012, 06:55 PM
RE: Philco 37-361 - by Ron Ramirez - 04-24-2012, 07:30 PM
RE: Philco 37-361 - by cmhsr - 04-24-2012, 07:50 PM
RE: Philco 37-361 - by Ron Ramirez - 04-24-2012, 09:06 PM
RE: Philco 37-361 - by cmhsr - 04-24-2012, 09:51 PM
RE: Philco 37-361 - by cmhsr - 04-25-2012, 09:31 PM
RE: Philco 37-361 - by cmhsr - 04-27-2012, 06:39 PM
RE: Philco 37-361 - by Ron Ramirez - 04-27-2012, 08:45 PM
RE: Philco 37-361 - by cmhsr - 04-28-2012, 09:03 AM
RE: Philco 37-361 - by cmhsr - 04-28-2012, 06:50 PM
RE: Philco 37-361 - by cmhsr - 04-29-2012, 12:28 PM
RE: Philco 37-361 - by Ron Ramirez - 04-29-2012, 02:06 PM
RE: Philco 37-361 - by cmhsr - 04-29-2012, 04:23 PM
RE: Philco 37-361 - by cmhsr - 04-29-2012, 04:29 PM
RE: Philco 37-361 - by cmhsr - 05-01-2012, 03:40 PM
RE: Philco 37-361 - by John R - 05-01-2012, 04:51 PM
RE: Philco 37-361 - by cmhsr - 05-01-2012, 06:58 PM
RE: Philco 37-361 - by cmhsr - 05-11-2012, 10:08 AM
RE: Philco 37-361 - by cmhsr - 05-11-2012, 10:40 AM
RE: Philco 37-361 - by cmhsr - 05-23-2012, 06:06 PM
Philco 37-361 - by cmhsr - 04-23-2012, 07:36 PM



Users browsing this thread: 5 Guest(s)
[-]
Recent Posts
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Hi Cap'n Clock, Unfortunately, I do not have this radio.  This is a shame because this should be a good performer.  2A5...MrFixr55 — 06:48 AM
American Bosch Model 802 auto radio
I think it would come under either American Bosch or United American Bosch. American Bosch made sets for the American We...Arran — 05:53 AM
trying to identify this wire type
Thanks to all for the feedback. As Arran said, it is probably an older replacement and yes it has a grid cap so I will ...georgetownjohn — 09:32 PM
trying to identify this wire type
It's possible that the red wire, actually a grid cap lead, is a very old replacement, I can't remember seeing a pre 1939...Arran — 09:18 PM
Gilfillan Brothers Car Radio?
Hi everyone,  Special thanks to Joe Rossi for tracking down this obscure radio and thanks to others who took up the hun...Antipodal — 08:15 PM
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration