Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco Deluuxe 95 B+ block rebuild
#3

[Image: http://inlinethumb54.webshots.com/23861/...600Q85.jpg]

http://home-and-garden.webshots.com/phot...9633uxVbdV As you can see the chassis is in good condition without a lot of corrosion so I wanted to keep it as close to original as possible. The audio PP tranformer has been replaced with a modern version but I have a model 96 so I will check if the part numbers are the same for the one on the model 96 and swap it onto this one and put this modern one on the model 96, (more of a basket case) along with the original type cap that was replaced when the transformer was replaced.


Messages In This Thread
Philco Deluuxe 95 B+ block rebuild - by 49Stude63 - 12-26-2006, 10:52 AM
[No subject] - by Chuck Schwark - 12-26-2006, 12:00 PM
[No subject] - by 49Stude63 - 12-26-2006, 12:08 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
New Philco Repair Bench
I am sure this is the archive, and not the Chuck's site.morzh — 09:50 PM
Made mistake & did not label connection
It's not like we are good friends with that wire and can tell it from other ptetty identical looking wires. Why'n't you...morzh — 09:49 PM
Made mistake & did not label connection
I'm not sure why that wire wasn't covered in the video. I'm pretty sure the 6A8 won't work until that pin is grounded. Y...RodB — 09:47 PM
Made mistake & did not label connection
You'll have to forgive me, I am not sure what you mean.  Can you explain what you are really saying.  If anyone does not...georgetownjohn — 08:05 PM
Made mistake & did not label connection
Those are details better left to the ones who know. Maybe you disconnected the wrong end of the wire.RodB — 06:22 PM
Made mistake & did not label connection
Maybe this is starting to make some sense in my hard head.  Is this why the wire in question was not in the great Ron Ra...georgetownjohn — 04:34 PM
Made mistake & did not label connection
I was correct with the 6A8 pin connection's, 7 and 8 are connected to ground as well as the tube shield (the broken line...RodB — 02:41 PM
Made mistake & did not label connection
What does the dotted line representing that surrounds the tube in the schematic?georgetownjohn — 02:17 PM
Made mistake & did not label connection
Hello John, I have been there either label got lost or was not labeled ! Sincerely Richardradiorich — 02:15 PM
Made mistake & did not label connection
Sorry, it is a Philco 37-640.  Does that help?--Johngeorgetownjohn — 02:14 PM

[-]
Who's Online
There are currently no members online.

>