Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Opinions please on this Zenith console
#6

(05-02-2012, 09:04 PM)Gene Pederson Wrote:  ......I must have gotten hypnotized by that motorized tuning....
They can do that Icon_wink ! '38 is one of my favorite year Zenith chassis because of the motorized tuning and shutter-dial. I still have my first '38, a 9-S-262 I picked up complete for $25 many, many moons ago at the now defunct Washington Court House, Ohio flea market.

(05-02-2012, 09:39 PM)morzh Wrote:  I will have to fix motorized tuning in mine - I was told the motor runs but the arrow does not move. Could be gears...could be, the motor does not run. Icon_smile
If the motor does in fact run then it is probably just the motor drive belt. That chassis uses two belts, one for the motor and one for the tuning and it isn't unusual to have one or both needing replacement. Some guys make their own, some find the right size "O" rings to use, and some order belts from Adams:

http://adamsradio.com/page1.html

http://www.alanjesperson.com/gn_repro.ht...al%20Belts




John KK4ZLF
Lexington, KY
"illegitimis non carborundum"


Messages In This Thread
RE: Opinions please on this Zenith console - by Eliot Ness - 05-03-2012, 06:15 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Cannot Adjust an IF Transformer’s cores
Outstanding work indeed. I wish I could come up with solutions like this.slford310 — 11:16 PM
Cannot Adjust an IF Transformer’s cores
The abilities of our 'Phorum Pholks" never ceases to amaze me! Fantastic fabrication, Joseph! I'm waiting now for...GarySP — 08:27 PM
PT-6 antenna connections
Thanks. I never realized that was a notch noted in the schematic as described. I’ll recheck my wiring.bridkarl — 08:13 PM
Cannot Adjust an IF Transformer’s cores
Thank you! I was quite new to the Phorum when I started this post, so I feel like it might be advantageous to publish a ...jrblasde — 08:07 PM
PT-6 antenna connections
Notice in the schematic the notch at the bottom of the antenna coil is between pins 3 & 4. Yes, pin 6 of the 7C6 is...RodB — 07:34 PM
bridkarl
I have two PT-6 chassis. On both there is a blue wire that runs from the above chassis transformer to pin 6 of 7C6. So t...bridkarl — 07:23 PM
Cannot Adjust an IF Transformer’s cores
Joseph, now you are an engineer!!RodB — 06:37 PM
PT-6 antenna connections
Hi, reading your explanation I can see the confusion. If you take it one connection at a time it should result in a desi...RodB — 06:34 PM
Cannot Adjust an IF Transformer’s cores
It works! I received the PCBs this morning in the mail, and put everything together. I reused the base from the original...jrblasde — 04:32 PM
PT-6 antenna connections
I seem to have lost my way on this PT-6. I see the antenna aerial transformer schematic - I’m reading pins 1 through ...bridkarl — 12:30 PM

[-]
Who's Online
There are currently no members online.

>