37-630 Recapping

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

37-630 Recapping

rghines1
Member

Posts: 190
Threads: 8
Joined: Oct 2005
City: Lexington, SC

12-31-2006, 10:51 PM

Normally go ahead and remove the RF chassis from the main chassis. There are about a dozen wires that can be slipped off from the terminal strips by just heating up the lugs. Label the wires and make a sketch as you remove the wires. Maintain the integrity of the tinned wire ends to make it easy to solder them back later. The wire under the cloth insulation is usually too tarnished to solder well. Then remove the hardware holding the RF chassis and lift it out with the wire harnesses. Not as bad as it sounds.

Richard

Find

« Next Oldest | Next Newest »

Messages In This Thread

37-630 Recapping - by n9vu - 12-29-2006, 10:32 PM

[No subject] - by Chuck Schwark - 12-30-2006, 11:37 AM

[No subject] - by 49Stude63 - 12-30-2006, 11:51 AM

[No subject] - by Chuck Schwark - 12-30-2006, 12:07 PM

[No subject] - by n9vu - 12-30-2006, 05:35 PM

[No subject] - by rghines1 - 12-31-2006, 10:51 PM

View a Printable Version

Users browsing this thread: 2 Guest(s)

Recent Posts
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached. I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM

Who's Online

There are currently 6157 online users. [Complete List]
» 1 Member(s) | 6156 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me