Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Newest acquisition - a 37-670B
#4

Good deal, Steve Icon_thumbup

Bob: Here are some photos of the back of the set:

[Image: http://www.philcoradio.com/images/phorum..._00002.jpg]

Dirty, but more or less complete. The 6F6G output tubes and the rectifier are missing. Some tube shields are also missing.

[Image: http://www.philcoradio.com/images/phorum..._00005.jpg]

It has its original speaker!

[Image: http://www.philcoradio.com/images/phorum..._00003.jpg]

It has an export 110/220 power transformer. I have noticed many 37-670/2670/38-2670 sets use this transformer, but I don't know if all of them do.

[Image: http://www.philcoradio.com/images/phorum..._00004.jpg]

Some creative modifications. I do not yet know what the two toggle switches and the two prongs are for.

[Image: http://www.philcoradio.com/images/phorum..._00006.jpg]

Not a good photo, but it shows the original audio interstage transformer has been replaced at some point.

While I was trying to take these photos, I had a supervisor who kept trying to get into the pictures:

[Image: http://www.philcoradio.com/images/phorum..._00001.jpg]

Debbie's cat Nixy, who adopted me about three years ago. Icon_smile

--
Ron Ramirez
Ferdinand IN


Messages In This Thread
Newest acquisition - a 37-670B - by Ron Ramirez - 05-17-2012, 07:11 PM
RE: Newest acquisition - a 37-670B - by Ron Ramirez - 05-18-2012, 05:15 PM
RE: Newest acquisition - a 37-670B - by Arran - 05-18-2012, 08:31 PM
RE: Newest acquisition - a 37-670B - by TA Forbes - 05-19-2012, 10:03 AM
RE: Newest acquisition - a 37-670B - by codefox1 - 05-19-2012, 05:32 PM
RE: Newest acquisition - a 37-670B - by TA Forbes - 05-19-2012, 09:15 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 38-7 Oscillation
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 11:16 PM
Philco 38-7 Speaker
I know that when I first started working on this radio, I did not even have a speaker. Once I finally found one it was n...tludka — 11:00 PM
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM

[-]
Who's Online
There are currently no members online.

>