Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Magnavox model 198C restoration
#19

I haven't finnished 198C yet. I'm waylaid.
However, I finally got back on radio in my 1947 Magnavox tv, radio, phono.
CR-217 radio...

AM, and, SW are playing great. However, FM is totally dead. Not even static..

I had to replace 5" round electromagnet tweeters because they were shot.
I kept the fields in circuit, though.
I mounted two 4.5" rect. spkrs., and, wired up the voice coulds the way the originals were, including choke in serieds between them.

I haven't had this set plugged in in 8 years due to manny problems.
Today, I brought it up on variac.
The radio plays great!
Tweeters are working flawlessly....
This set has wonderful frequency response, and, that contour switch for the treble works great....
After I'm sure it's fixed, I'll re mount spkr. system, then, work on getting the tv to work again...
I got this set rebuilt in a trade from John Folsom about 9 years ago...
It had lusy sound because of the wreckied tweeters....
TV is a 12" set.
Phono is a two spd. WC.
Bill Cahill

"If it lights in the dark and leaves you with a warm glow it's tubes."

"Honey, did you warm the baby bottle on my 75 watt hi-fi again?"
"I left it somewhere, but, where?"


Messages In This Thread
Magnavox model 198C restoration - by Bill Cahill - 03-15-2011, 01:35 PM
RE: Magnavox model 198C restoration - by Bill Cahill - 05-26-2012, 12:10 AM
Re: Magnavox model 198C restoration - by w4rtc - 03-15-2011, 05:23 PM
Re: Magnavox model 198C restoration - by w4rtc - 04-06-2011, 10:16 AM
Re: Magnavox model 198C restoration - by w4rtc - 04-06-2011, 03:33 PM



Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently 4639 online users. [Complete List]
» 4 Member(s) | 4635 Guest(s)
AvatarAvatarAvatarAvatar

>