1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco 37-84 code 121
Radioroslyn
Phorum Expert
*****
Posts: 7,296
Threads: 268
Joined: Dec 2009
City: Roslyn Pa
#4

05-31-2012, 03:34 PM
Search this phourm for model 84. More than likely the antenna and osc coil are bad. The phourm has the info how to repair them. You will find that just about all of the resistors are out of spec so replace them. On these sets it is important to use a signal generator to align the IF. Some try to do it by ear but that is a bad move!!
Terry
Find
« Next Oldest | Next Newest »
Thread Closed


Messages In This Thread
Philco 37-84 code 121 - by Eric - 05-30-2012, 09:20 AM
RE: Philco 37-84 code 121 - by Ron Ramirez - 05-30-2012, 04:40 PM
RE: Philco 37-84 code 121 - by ABV - 08-24-2016, 07:27 PM
RE: Philco 37-84 code 121 - by Eric - 05-31-2012, 03:14 PM
RE: Philco 37-84 code 121 - by 7estatdef - 05-31-2012, 03:34 PM
RE: Philco 37-84 code 121 - by Eric - 06-04-2012, 06:21 PM
RE: Philco 37-84 code 121 - by 7estatdef - 06-04-2012, 07:30 PM
RE: Philco 37-84 code 121 - by AI2V - 06-05-2012, 09:52 AM
RE: Philco 37-84 code 121 - by Eric - 06-07-2012, 03:50 PM
RE: Philco 37-84 code 121 - by Ron Ramirez - 08-24-2016, 08:12 PM
RE: Philco 37-84 code 121 - by ABV - 08-25-2016, 07:47 AM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 610B oscillator wiring
> The cathode as noted is wired directly to the ground side of the heater filament for that tube, not to the #17 and ...Radioroslyn — 08:12 PM
HiFi (Chifi) tube amp build - but my own design.
Tim; O noticed your post a little late, but I would take one of the junk sockets and try to break a chunk out of it w...Arran — 08:07 PM
Need to purchase some accessories for restoration of my Old Philco Radio
Here is a list of resources found in our online library that you might find useful. Mike's Gobs of Knobs email addres...klondike98 — 01:46 PM
First Radio restoration
Hi Tubeman, Welcome to the Philco Phorum.  Phamily Phriendly Pfun with Phine Pholks Phull of Philco Phacts. (See a p...MrFixr55 — 12:33 PM
First Radio restoration
You could post in the WANTED ADs section here on the Phorum and see if anyone has an RF generator that they want to sell...klondike98 — 11:55 AM
Zenith H725
Good ideas, thank you Arrange and Rich. I have the adhesive aluminum foil already and can try that immediately. More ...EdHolland — 10:18 AM
Graphics for majestic 1050 dial glass.
Murf; I found this thread on the ARF, the first photo has a pretty good view of the dial glass. Regards ArranArran — 01:12 AM
Zenith H725
hello Ed, how about that speacial tape used for ducting it's like foil or how about thin piece of aluminum roof flash...radiorich — 12:19 AM
Zenith H725
Ed; One material that I have seen, but never tried for this was material for making exhaust gaskets, it's similar to ...Arran — 11:42 PM
Zenith H725
I just remembered, I have some hi temp silicone rubber material which could do the trick. Or a piece of FR4 laminate. Th...EdHolland — 08:39 PM

[-]
Who's Online
There are currently 1604 online users. [Complete List]
» 2 Member(s) | 1602 Guest(s)
AvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration