Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Storage Wars Philco tonight
#4

Arran,
I saw that too about the Isetta. The Petersen Auto museum was where Barry took the car. Inflated prices for sure. Even a best case scenario, that car would not be worth the amount he said. IIRC, his estimate of the car's value as is was around $800. It needed a total resto.

I don't watch Storage Hunters (short scrawny guy with the loudmouth wife). Tru TV should be called fake TV. Same acors, finding Lambos, rockets, meth labs etc.

Storage Wars uses actual folks that have been in the business for years and have retail outlets. What you see is just a fraction of what they end up with. Thy of course don't show the 90% of junk they usually end up with.

As far as drivel, there are far worse shows on, filth, disrespect for adults, asinine behavior that is supposed to be funny.
I don't mean this to be a discussion about the show itself, but was only asking if someone knew the radio collector they went to.


Messages In This Thread
Storage Wars Philco tonight - by gary rabbitt - 06-06-2012, 01:38 AM
RE: Storage Wars Philco tonight - by Arran - 06-06-2012, 02:19 AM
RE: Storage Wars Philco tonight - by TA Forbes - 06-06-2012, 09:10 AM
RE: Storage Wars Philco tonight - by gary rabbitt - 06-06-2012, 03:12 PM
RE: Storage Wars Philco tonight - by TA Forbes - 06-06-2012, 04:10 PM
RE: Storage Wars Philco tonight - by Arran - 06-06-2012, 07:06 PM
RE: Storage Wars Philco tonight - by PHILLYPHILCO - 06-06-2012, 07:30 PM
RE: Storage Wars Philco tonight - by Arran - 06-06-2012, 08:01 PM
RE: Storage Wars Philco tonight - by TA Forbes - 06-06-2012, 10:39 PM
RE: Storage Wars Philco tonight - by gary rabbitt - 06-07-2012, 04:33 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
Usually a wave trap is for keeping IF signals from entering the antenna and from leaving the antenna. You feed an IF sig...RodB — 09:30 PM
Philco 60 Squealing
I just peaked it for the best signal at 600. NULL it for IF frequency, originally it would have been null for 500kh...Chas — 08:05 PM
Philco 60 Squealing
Wavetrap no longer matters.morzh — 05:19 PM
Philco 60 Squealing
Rod, I had checked out your suggestions but did not help. I did solder the ground rivets to the chassis as Chas suggeste...dconant — 04:52 PM
37-690 Bass Choke Replacement
Yeah, I know, Mouser and Digikey don't have "big iron" components. For some reason Philco was messing with the...Radiodial — 04:25 PM
37-690 Bass Choke Replacement
Yes, I just had to deal with that while repairing the 37-604 Philco. Exactly that value choke was gone. And the current ...morzh — 03:52 PM
37-690 Bass Choke Replacement
Ah, now where to find one. I've into this before on smaller sets, I now recall. Hammond makes one that is only rated...Radiodial — 03:27 PM
Philco 38-7 Speaker
Ask the admins to put them together. As for the renaming, while inside the thread, you simply press "New reply&quo...morzh — 02:23 PM
37-690 Bass Choke Replacement
This is the parts catalog. 32-7528 choke is 65H, 10mA, 2,250 Ohm inductance. Find a suitable one.morzh — 02:18 PM
37-690 Bass Choke Replacement
While troubleshooting the no bass amplification issue, I think I found the culprit. The choke #104 is reading 164K ohms....Radiodial — 01:42 PM

[-]
Who's Online
There are currently 4113 online users. [Complete List]
» 3 Member(s) | 4110 Guest(s)
AvatarAvatarAvatar

>