1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco 43B - IF Tube Shield Question
Chuck Schwark
Phorum Expert
*****
Posts: 1,703
Threads: 55
Joined: Sep 2005
City: Evanston, IL
#2

02-21-2007, 09:52 PM
Don't think it's original. It would not be necessary anyway due to the partitioning. Sufficient shielding. Someone obviously bent it to remove tubes. If it were original, it would be as high as the two-section cowl it's in front of and have the same dull grey appearance.

The two self-tapping sheet-metal screws holding it look too new as well.
Chuck Schwark,
The Philco Repair Bench
[Image: http://www.philcorepairbench.com/images/philog3tiny.gif]
http://www.philcorepairbench.com
Website Find
« Next Oldest | Next Newest »


Messages In This Thread
Philco 43B - IF Tube Shield Question - by davemc - 02-21-2007, 05:48 PM
[No subject] - by Chuck Schwark - 02-21-2007, 09:52 PM
[No subject] - by davemc - 02-22-2007, 07:50 AM
[No subject] - by davemc - 02-23-2007, 05:09 PM
[No subject] - by davemc - 02-26-2007, 07:18 AM
[No subject] - by Chuck Schwark - 02-26-2007, 09:25 AM



Users browsing this thread: 1 Guest(s)
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration