1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
38 116 low volume after recapp
Radioroslyn
Phorum Expert
*****
Posts: 7,286
Threads: 268
Joined: Dec 2009
City: Roslyn Pa
#5

06-07-2012, 09:14 PM
Shorted 6L6?? As mentioned measure the voltage on pin 5 of BOTH 6L6's. Should see -20v or better on both. If only see - voltage on one of the 6L6's You have a bad driver transformer.
Terry
Find
« Next Oldest | Next Newest »


Messages In This Thread
38 116 low volume after recapp - by SteveJB - 06-07-2012, 03:03 PM
RE: 38 116 low volume after recapp - by rghines1 - 06-07-2012, 03:58 PM
RE: 38 116 low volume after recapp - by 7estatdef - 06-07-2012, 09:14 PM
RE: 38 116 low volume after recapp - by SteveJB - 06-07-2012, 09:42 PM
RE: 38 116 low volume after recapp - by 7estatdef - 06-08-2012, 06:54 AM
RE: 38 116 low volume after recapp - by SteveJB - 06-08-2012, 10:17 AM
RE: 38 116 low volume after recapp - by codefox1 - 06-08-2012, 11:09 AM
RE: 38 116 low volume after recapp - by SteveJB - 06-08-2012, 11:34 AM
RE: 38 116 low volume after recapp - by rghines1 - 06-08-2012, 04:41 PM
RE: 38 116 low volume after recapp - by SteveJB - 07-17-2012, 06:39 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration