Model 60 decal

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Model 60 decal

codefox1
Silent Key

Posts: 2,128
Threads: 18
Joined: Oct 2008
City: Merrick, Long Island, NY

#15

06-15-2012, 09:13 PM

Make it correct. Can't take it very long to get a correct font or near enough, and scale appropriately, then run of dozens of decals on a single sheet and clip them up and peddle them. Only a few hundred customers out there, so make friends here!

Find

« Next Oldest | Next Newest »

Messages In This Thread

Model 60 decal - by sjhs1962 - 06-09-2012, 03:03 PM

RE: Model 60 decal - by Ron Ramirez - 06-09-2012, 10:44 PM

RE: Model 60 decal - by sjhs1962 - 06-10-2012, 11:49 AM

RE: Model 60 decal - by TA Forbes - 06-10-2012, 02:07 PM

RE: Model 60 decal - by Steve Davis - 06-11-2012, 10:08 AM

RE: Model 60 decal - by Ron Ramirez - 06-11-2012, 10:24 AM

RE: Model 60 decal - by Michael Dennis - 06-11-2012, 11:54 PM

RE: Model 60 decal - by Ron Ramirez - 06-13-2012, 06:38 PM

RE: Model 60 decal - by Steve Davis - 06-13-2012, 09:03 PM

RE: Model 60 decal - by Steve Davis - 06-13-2012, 10:29 PM

RE: Model 60 decal - by Ron Ramirez - 06-14-2012, 05:19 AM

RE: Model 60 decal - by TA Forbes - 06-14-2012, 10:09 PM

RE: Model 60 decal - by TA Forbes - 06-14-2012, 10:25 PM

RE: Model 60 decal - by Ron Ramirez - 06-15-2012, 09:03 PM

RE: Model 60 decal - by codefox1 - 06-15-2012, 09:13 PM

RE: Model 60 decal - by Ron Ramirez - 06-19-2012, 08:58 AM

RE: Model 60 decal - by Steve Davis - 06-19-2012, 03:20 PM

RE: Model 60 decal - by Glenn Roberts - 06-19-2012, 03:58 PM

RE: Model 60 decal - by Eliot Ness - 06-19-2012, 04:21 PM

RE: Model 60 decal - by Steve Davis - 06-19-2012, 10:11 PM

RE: Model 60 decal - by TA Forbes - 06-20-2012, 02:55 AM

RE: Model 60 decal - by Ron Ramirez - 06-20-2012, 07:49 AM

View a Printable Version

Users browsing this thread: 5 Guest(s)

Recent Posts
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM
Model 28L
Hello, I'm restoring a Philco 28L and the output transformer is open. Part number of the transformer is 32-7020. Can...HORSTE — 10:32 AM

Who's Online

There are currently 3441 online users. [Complete List]
» 2 Member(s) | 3439 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me