1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Revisiting my 7S363
TA Forbes
Deviate Emeritus
*****
Posts: 2,353
Threads: 92
Joined: May 2010
City: Clayton, NC
#7

06-16-2012, 09:45 PM
I should think that 10W is plenty.

Personally, I check resistors and replace those outside 20 percent of their stated value.

Bear in mind that you may have to pull one side of your resistor to get a good reading.
Find
« Next Oldest | Next Newest »


Messages In This Thread
Revisiting my 7S363 - by LedHed - 06-15-2012, 10:28 PM
RE: Revisiting my 7S363 - by rghines1 - 06-16-2012, 10:22 AM
RE: Revisiting my 7S363 - by morzh - 06-16-2012, 11:41 AM
RE: Revisiting my 7S363 - by codefox1 - 06-16-2012, 01:46 PM
RE: Revisiting my 7S363 - by LedHed - 06-16-2012, 06:57 PM
RE: Revisiting my 7S363 - by morzh - 06-16-2012, 07:02 PM
RE: Revisiting my 7S363 - by TA Forbes - 06-16-2012, 09:45 PM
RE: Revisiting my 7S363 - by codefox1 - 06-17-2012, 02:19 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
AC/DC Transformer-less Sets
Good evening, folks. Power station engineer here! The east coast had pockets of DC-only power well into the twentieth...jrblasde — 10:11 PM
AC/DC Transformer-less Sets
Model 40 does not have a rectifier, so it would be a DC only model. This however does not say anything about using...morzh — 08:01 PM
AC/DC Transformer-less Sets
I was wondering if anyone knows if these AC/DC transformer-less sets were actually used on 110v DC anywhere, and when. ...PeterN — 06:35 PM
Looking for place to donate unique Philco Philco J-1930 Prototype
Given the 1960s vintage, it is likely that the cartridge is ceramic, likely more stable. The changer looks like a Voice...MrFixr55 — 05:03 PM
Jackson 665 j2 schematic request
FIXED!daveone23 — 03:55 PM
Bakelite crack repair - what is best epoxy?
Thanks everyone. I appreciate you sharing your experience and looks like I'll work with the 24 hr two part clear epoxy....de371 — 10:25 PM
Jackson 665 j2 schematic request
Without a schematic its going to be hard tracing the wire wound spool resistors.daveone23 — 05:21 PM
Jackson 665 j2 schematic request
Looking for a schematic for the 665 j2 multimeter.daveone23 — 04:42 PM
Looking for place to donate unique Philco Philco J-1930 Prototype
>>I'll write to the Henry Ford. I heard, his secretary answers his mail, not he himself.morzh — 12:15 PM
Philco 48-200 alignment questions
Just checked the power cord and I did in fact wire it so the hot side (small prong) goes to the switch.transitony — 11:52 AM

[-]
Who's Online
There are currently 1977 online users. [Complete List]
» 2 Member(s) | 1975 Guest(s)
AvatarAvatar

>
  1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)