|
custom built transformer question
06-19-2012, 06:05 PM
I recently had a company build a replacement transformer for my Philco 18. It was specced out to be 120v primary / 760v center tapped per the Philco 18 code 124 schematics. Problem is that I am getting 420v from each leg, which means 840v total. The company says that they build in 10% higher voltage under no load conditions. Is this acceptable? The rectifier tube is a #80 which I thought was good up to 800v.
Don
« Next Oldest | Next Newest »
Messages In This Thread
custom built transformer question - by raydog - 06-19-2012, 06:05 PM
RE: custom built transformer question - by Ron Ramirez - 06-19-2012, 06:45 PM
RE: custom built transformer question - by raydog - 06-19-2012, 07:12 PM
RE: custom built transformer question - by Ron Ramirez - 06-19-2012, 07:57 PM
RE: custom built transformer question - by codefox1 - 06-19-2012, 08:10 PM
RE: custom built transformer question - by Arran - 06-19-2012, 08:45 PM
Users browsing this thread: 1 Guest(s) |
|
|
![[-]](https://philcoradio.com/phorum/images/bootbb/collapse.png "[-]")
