Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

46-1209
#1

Just did my first recap on a 46-1209. When I turn it on I hear a strange noise as the tubes are warming up. Sounds like it is coming from either the 6v6's or the 5y3. I don't smell anything burning and any advise would be helpfully. I did not let it fully warm up.

Thank you


Messages In This Thread
46-1209 - by philco4me - 06-21-2012, 11:58 AM
RE: 46-1209 - by TA Forbes - 06-21-2012, 12:34 PM
RE: 46-1209 - by philco4me - 06-21-2012, 01:05 PM
RE: 46-1209 - by TA Forbes - 06-21-2012, 01:15 PM
RE: 46-1209 - by philco4me - 06-21-2012, 01:19 PM
RE: 46-1209 - by philco4me - 06-21-2012, 01:47 PM
RE: 46-1209 - by Marsupial - 06-21-2012, 01:49 PM
RE: 46-1209 - by philco4me - 06-21-2012, 02:08 PM
RE: 46-1209 - by philco4me - 06-21-2012, 04:58 PM
RE: 46-1209 - by Marsupial - 06-22-2012, 09:55 PM
RE: 46-1209 - by gary rabbitt - 06-22-2012, 11:50 PM
RE: 46-1209 - by codefox1 - 06-23-2012, 12:54 PM
RE: 46-1209 - by Marsupial - 06-23-2012, 03:58 PM
RE: 46-1209 - by D R FORD - 06-23-2012, 05:08 PM
RE: 46-1209 - by codefox1 - 06-23-2012, 05:32 PM
RE: 46-1209 - by philco4me - 06-25-2012, 01:01 PM
RE: 46-1209 - by philco4me - 07-02-2012, 10:20 AM



Users browsing this thread: 5 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM
Model 28L
Hello, I'm restoring a Philco 28L and the output transformer is open. Part number of the transformer is 32-7020. Can...HORSTE — 10:32 AM

[-]
Who's Online
There are currently no members online.

>