Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Mystery Control receiver
#16

Finally got the 50pf caps in and installed still nothing. I made an adapter per Ron's instructions and tried following the instruction for adjusting the control amps frequency for the 41-616 on my 39-55 but I can't get the meter to show any more then 50vac. None of the adjustments on the IF transformer cans made a difference the needle on the meter dosent move at all.

Guess its back to the drawing board, time to check everything against the schematic again.

Im open to any ideas.

-Keith


Messages In This Thread
Mystery Control receiver - by ipwizard - 06-05-2012, 12:50 AM
RE: Mystery Control receiver - by Ron Ramirez - 06-05-2012, 11:11 AM
RE: Mystery Control receiver - by ipwizard - 06-06-2012, 12:19 AM
RE: Mystery Control receiver - by codefox1 - 06-06-2012, 01:03 AM
RE: Mystery Control receiver - by w4rtc - 06-06-2012, 09:32 AM
RE: Mystery Control receiver - by w4rtc - 06-06-2012, 09:35 AM
RE: Mystery Control receiver - by Ron Ramirez - 06-06-2012, 10:58 AM
RE: Mystery Control receiver - by Ron Ramirez - 06-06-2012, 03:00 PM
RE: Mystery Control receiver - by ipwizard - 06-08-2012, 01:56 PM
RE: Mystery Control receiver - by Chuck Schwark - 06-08-2012, 03:14 PM
RE: Mystery Control receiver - by ipwizard - 06-08-2012, 04:58 PM
RE: Mystery Control receiver - by ipwizard - 06-09-2012, 01:49 AM
RE: Mystery Control receiver - by codefox1 - 06-09-2012, 01:53 AM
RE: Mystery Control receiver - by Ron Ramirez - 06-09-2012, 07:26 AM
RE: Mystery Control receiver - by ipwizard - 06-09-2012, 03:48 PM
RE: Mystery Control receiver - by ipwizard - 06-22-2012, 01:18 AM
RE: Mystery Control receiver - by ipwizard - 06-26-2012, 12:22 AM
RE: Mystery Control receiver - by Chuck Schwark - 06-26-2012, 10:51 AM
RE: Mystery Control receiver - by ipwizard - 06-26-2012, 01:47 PM
RE: Mystery Control receiver - by w4rtc - 06-26-2012, 07:10 PM
RE: Mystery Control receiver - by 7estatdef - 06-26-2012, 10:14 PM
RE: Mystery Control receiver - by ipwizard - 06-26-2012, 11:59 PM
RE: Mystery Control receiver - by 7estatdef - 06-27-2012, 06:38 AM
RE: Mystery Control receiver - by ipwizard - 01-16-2013, 08:53 PM
RE: Mystery Control receiver - by Chuck Schwark - 01-16-2013, 11:31 PM
RE: Mystery Control receiver - by ipwizard - 01-18-2013, 04:39 PM
RE: Mystery Control receiver - by ipwizard - 01-27-2013, 08:30 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
trying to identify this wire type
Thanks to all for the feedback. As Arran said, it is probably an older replacement and yes it has a grid cap so I will ...georgetownjohn — 09:32 PM
trying to identify this wire type
It's possible that the red wire, actually a grid cap lead, is a very old replacement, I can't remember seeing a pre 1939...Arran — 09:18 PM
Gilfillan Brothers Car Radio?
Hi everyone,  Special thanks to Joe Rossi for tracking down this obscure radio and thanks to others who took up the hun...Antipodal — 08:15 PM
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM

[-]
Who's Online
There are currently no members online.

>