Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12, 2025) x

Thread Closed

My New Philco 15x
#3

So after looking underneath, I have noticed a few things and have a few questions.

Mershon Capacitors
Did this model have the Mershon caps originally? I notice the two caps on mine are stamped sprague, could they be originals? Looking underneath both Sprauge's are disconnected. In place are two Aerovox as it would seem.

The Transformer
It looks as though the power transformer is a old replacement long ago, it reads "Stancore" on it" and there is wax drippings visible below inside the chassis Which makes me concerned. I am almost sure the Power transformer is quite bigger than this one is. There is also plastic wire visible on the underside. Could anybody tell me if this is a replacement? And can anybody tell me where to find a good original that is in good shape with the cloth wire still intact?

Audio Transformers
That leads me to believe these audio transformers are also replacements, they don't have philco printed on the clam shells. Can anybody tell if they are also replacements?

Capacitors
Looks as those the original capacitors have also been replaced with the bumble bee's, those two black caps in the bottom right, replaced in the 50? Also did this set originally have any paper wax capacitors? all the Bakelite blocks are there.

The resistors are original as well as the speakers, most everything is original to the radio from my observation, but I am still very new with this model and this old of a Philco. Please help if you guys can and in any way possible. I'm still new to the hobby, with now only one restoration under my belt, I am just getting my bearings with the 15x.


Attached Files Image(s)
                   


Messages In This Thread
My New Philco 15x - by Philco281989 - 06-28-2012, 04:54 PM
RE: My New Philco 15x - by Glenn Roberts - 06-28-2012, 06:06 PM
RE: My New Philco 15x - by Philco281989 - 06-28-2012, 06:24 PM
RE: My New Philco 15x - by Philco281989 - 06-28-2012, 06:44 PM
RE: My New Philco 15x - by 37silverstreak - 06-28-2012, 07:21 PM
RE: My New Philco 15x - by Philco281989 - 06-28-2012, 10:48 PM
RE: My New Philco 15x - by Bob Andersen - 06-29-2012, 12:24 AM
RE: My New Philco 15x - by Philco281989 - 06-29-2012, 08:49 AM
RE: My New Philco 15x - by Bob Andersen - 06-29-2012, 08:26 PM
RE: My New Philco 15x - by Philco281989 - 06-29-2012, 08:43 PM
RE: My New Philco 15x - by Arran - 06-29-2012, 09:08 PM
RE: My New Philco 15x - by Philco281989 - 06-29-2012, 09:48 PM
RE: My New Philco 15x - by Arran - 06-29-2012, 11:34 PM
RE: My New Philco 15x - by Bob Andersen - 06-30-2012, 07:33 PM
RE: My New Philco 15x - by CrumblingWires - 06-30-2012, 09:42 PM
RE: My New Philco 15x - by Philco281989 - 06-30-2012, 09:52 PM
RE: My New Philco 15x - by Bob Andersen - 07-01-2012, 02:50 PM
RE: My New Philco 15x - by Philco281989 - 07-01-2012, 03:43 PM
RE: My New Philco 15x - by Ron Ramirez - 07-11-2012, 04:19 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
54C Complete Teardown/Rebuild
Hello Roy, here is this one sincerely Richardradiorich — 12:45 AM
54C Complete Teardown/Rebuild
Richard, Had grabbed it already but thank you just the same.  I find myself wanting to find some way to block out the...glyphmon — 12:03 AM
54C Complete Teardown/Rebuild
Hello roy, here is a link to the schematic . Sincerely Richardradiorich — 11:54 PM
54C Complete Teardown/Rebuild
Richard, The Silvertone 2014 also is a transformerless set, so I am incorporating a 1:1 600 ohm audio isolation transfo...glyphmon — 11:37 PM
Preliminary work on wife's Silvertone 2014
Did an alignment today which was interesting.  IF alignment went great, almost all was already spot-on.  Adjusting on th...glyphmon — 11:35 PM
54C Complete Teardown/Rebuild
The main problem with adding a Bluetooth input is that this set lacks a traditional power transformer to isolate it from...radiorich — 11:19 PM
54C Cabinet Refinish
I started stripping this cabinet before it got super chilly out because I knew I wasn't going to be able to work on ...glyphmon — 11:18 PM
54C Complete Teardown/Rebuild
While I'm waiting to wrap up the final steps on my wife's Silvertone 2014, I started disassembly on the next project.  O...glyphmon — 11:07 PM
Preliminary work on wife's Silvertone 2014
Hello roy, that great news glad it worked out for you !! Sincerely Richardradiorich — 10:50 PM
Preliminary work on wife's Silvertone 2014
Safety caps arrived today.  Soldered one in and had a successful first power-up.  No magic smoke escaped and it tunes in...glyphmon — 09:53 PM

[-]
Who's Online
There are currently 1552 online users. [Complete List]
» 1 Member(s) | 1551 Guest(s)
Avatar

>