Tuning Condenser rubber mounts for model 38-10

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Tuning Condenser rubber mounts for model 38-10

BOB C.
Junior Member

Posts: 11
Threads: 4
Joined: Mar 2007

03-19-2007, 09:28 PM

Thanks guys. I don't know if 38-12 and the 38-10 have the same mounting setup. I really don't see how I could use a rubber grommet for this setup as it is a rectangular tab going into a rectangular hole. The factory rubber slips over prongs on either side of the chassis. I will check out the grommet selection and see whats in there.
Also thanks for the tip on the shields. I will give him a call. Bob

Robert Chesarek
Renfrew, PA

Find

« Next Oldest | Next Newest »

Messages In This Thread

Tuning Condenser rubber mounts for model 38-10 - by BOB C. - 03-18-2007, 03:58 PM

Condenser mounts fix - by ecmorris - 03-18-2007, 06:29 PM

Tuning condenser rubber mounts for model 38-10 - by William - 03-18-2007, 07:30 PM

[No subject] - by BOB C. - 03-19-2007, 09:28 PM

[No subject] - by planigan - 03-21-2007, 12:22 AM

[No subject] - by Bill Hutchinson - 03-21-2007, 01:17 PM

View a Printable Version

Users browsing this thread: 2 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me