Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Bought another console! Pictures added!
#9

Thank you for the response T.A. Yes, my 112 had a number of globe Philco tubes in it, and a number or replacement non-globe tubes. I was surprised to see no globes and virtually all the Cunnigham tubes. But they look old with the engraving. All measure weak to pathetic on my tube tester. Only good one was the 80. The radio seems to work well. I will just wait until I have time to go through the electronics. Perhaps someone just sold them a complete new set of tubes in the past as you suggested.
Jerry

A friend in need is a pest!  Bill Slee ca 1970.


Messages In This Thread
RE: Bought another console! - by codefox1 - 07-05-2012, 11:26 PM
RE: Bought another console! - by TA Forbes - 07-06-2012, 01:06 PM
RE: Bought another console! - by jerryhawthorne - 07-06-2012, 03:07 PM
RE: Bought another console! Pictures added! - by jerryhawthorne - 07-11-2012, 04:42 PM



Users browsing this thread: 5 Guest(s)
[-]
Recent Posts
Shadow Meter Bulb
Not sure if anyone has tried this but there are 6.3 volt miniature lamps in bayonet and screw-in base options available ...GarySP — 11:31 AM
Shadow Meter Bulb
Any 6.3 volt pilot light will work. I would use the brightest one I could find in my workroom. Be sure the dial is clean...RodB — 10:45 AM
HiFi (Chifi) tube amp build - but my own design.
Tim, nice write up and thanks for sharing !! Sincerely Richardradiorich — 02:47 AM
HiFi (Chifi) tube amp build - but my own design.
Well, this was a real "Hum-Dinger" :lol: ! This will be kinda long, but hopefully it will help others having t...TV MAN — 01:55 AM
Shadow Meter Bulb
Phorum members, I am trying to find the bulb # for PHILCO Shadow Meter part number 45-2180 that is from a 37-640 chassis...georgetownjohn — 06:53 PM
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM

[-]
Who's Online
There are currently no members online.

>