1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Voltages-socket pins for Mystery Control
batterymaker
Member
***
Posts: 104
Threads: 11
Joined: Oct 2005
City: Indianapolis, IN
#35

11-06-2005, 10:44 PM
Okay--so the good news--it fits, can stand to be thicker.

Bad news--the spring brass is too thin to work properly. I'll see about upgrading to a thicker variety.

Other than that, it's working good, right?

Bill
Find
« Next Oldest | Next Newest »


Messages In This Thread
[No subject] - by Chuck Schwark - 10-04-2005, 03:12 PM
[No subject] - by Ron Ramirez - 10-04-2005, 06:09 PM
[No subject] - by Chuck Schwark - 10-04-2005, 07:01 PM
[No subject] - by Chuck Schwark - 10-04-2005, 08:08 PM
[No subject] - by batterymaker - 10-04-2005, 10:38 PM
[No subject] - by Chuck Schwark - 10-04-2005, 10:41 PM
[No subject] - by batterymaker - 10-05-2005, 09:39 PM
[No subject] - by Chuck Schwark - 10-05-2005, 10:48 PM
[No subject] - by Chuck Schwark - 10-12-2005, 11:53 PM
[No subject] - by batterymaker - 10-14-2005, 09:57 PM
[No subject] - by Chuck Schwark - 10-15-2005, 12:16 AM
[No subject] - by batterymaker - 10-15-2005, 09:54 AM
[No subject] - by Chuck Schwark - 10-15-2005, 07:05 PM
[No subject] - by batterymaker - 10-15-2005, 10:52 PM
[No subject] - by Chuck Schwark - 10-16-2005, 10:38 AM
[No subject] - by Chuck Schwark - 10-16-2005, 01:43 PM
[No subject] - by batterymaker - 10-16-2005, 10:56 PM
[No subject] - by batterymaker - 10-16-2005, 10:58 PM
[No subject] - by Chuck Schwark - 10-17-2005, 04:19 PM
[No subject] - by batterymaker - 10-19-2005, 09:25 AM
[No subject] - by Chuck Schwark - 10-19-2005, 09:54 AM
[No subject] - by batterymaker - 10-19-2005, 04:04 PM
[No subject] - by batterymaker - 10-20-2005, 06:18 PM
[No subject] - by Chuck Schwark - 10-20-2005, 10:59 PM
[No subject] - by batterymaker - 10-25-2005, 08:03 PM
[No subject] - by Chuck Schwark - 10-25-2005, 09:07 PM
[No subject] - by Ron Ramirez - 10-25-2005, 09:28 PM
[No subject] - by batterymaker - 10-25-2005, 10:07 PM
[No subject] - by Chuck Schwark - 10-26-2005, 09:16 AM
[No subject] - by batterymaker - 10-30-2005, 11:43 AM
[No subject] - by Chuck Schwark - 10-30-2005, 07:36 PM
[No subject] - by Chuck Schwark - 11-06-2005, 10:03 PM
[No subject] - by batterymaker - 11-06-2005, 10:44 PM
[No subject] - by Chuck Schwark - 11-06-2005, 11:00 PM
[No subject] - by batterymaker - 11-07-2005, 09:10 AM
[No subject] - by Chuck Schwark - 11-07-2005, 10:18 AM
[No subject] - by batterymaker - 11-07-2005, 03:58 PM
[No subject] - by Chuck Schwark - 11-07-2005, 05:24 PM
[No subject] - by batterymaker - 11-07-2005, 11:42 PM
[No subject] - by Chuck Schwark - 11-07-2005, 11:59 PM
[No subject] - by batterymaker - 12-01-2005, 09:25 AM
[No subject] - by Chuck Schwark - 12-01-2005, 10:04 AM
[No subject] - by Guest - 12-01-2005, 03:19 PM
[No subject] - by batterymaker - 12-06-2005, 10:43 AM
[No subject] - by batterymaker - 12-09-2005, 09:31 AM



Users browsing this thread: 19 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM
Model 28L
Hello, I'm restoring a Philco 28L and the output transformer is open. Part number of the transformer is 32-7020. Can...HORSTE — 10:32 AM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration