Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 89
#3

Offer him $35 or $40 for it, veneer missing and a bad finish is always a good way to get a few $$ taken off, hopefull the knobs that are there are the correct ones along with the speaker. I take it that this is a floor model 89 and not a cathedral? The next question is do you like it? Is there anything about it you don't like? Could you see yourself restoring the set and living with it for at least a few years? You shouldn't buy a floor model just because it's cheap, otherwise you may get stuck with a garage and house full of stuff you don't really want and not have room for things you would rather have. Floor models are like four door sedans, they are more expensive to restore then a table model version of the same set, aren't worth any more, and are harder to sell.
Regards
Arran


Messages In This Thread
Philco 89 - by w4rtc - 07-30-2012, 05:26 PM
RE: Philco 89 - by 7estatdef - 07-30-2012, 06:36 PM
RE: Philco 89 - by Arran - 07-30-2012, 06:52 PM
RE: Philco 89 - by Ron Ramirez - 07-30-2012, 07:35 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 16B Parts
The 16B's in the tombstone cabinet sport a 10 1/2" spkr vs the older cathedral sets which uses an 8". The p/p ...Radioroslyn — 12:58 AM
Philco 38-7 Oscillation
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 11:16 PM
Philco 38-7 Speaker
I know that when I first started working on this radio, I did not even have a speaker. Once I finally found one it was n...tludka — 11:00 PM
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM

[-]
Who's Online
There are currently no members online.

>