1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
I've done it again, #2 & 3
Ron Ramirez
Silent Key
*****
Posts: 13,776
Threads: 580
Joined: Sep 2005
City: Ferdinand State, Province, Country: Indiana
#2

09-03-2012, 04:51 PM
That was Scott #2, now here's #3.

A good friend in North Carolina sent me home with yet another Scott - an RBO communications receiver from WWII.

[Image: http://www.philcoradio.com/images/phorum..._00001.jpg]

(And I sincerely appreciate this and the Philco 35!)

So now I have two Scott military radios and an empty Allwave 23 Tasman cabinet, a Philharmonic speaker, and a McMurdo Silver Masterpiece VI to go along with a 1924 Super-Zenith VIII and the Philcos. I guess you could say I'm diversifying a bit. Icon_smile
--
Ron Ramirez
Ferdinand IN
Find
« Next Oldest | Next Newest »


Messages In This Thread
I've done it again, #2 & 3 - by Ron Ramirez - 09-03-2012, 04:45 PM
RE: I've done it again, #2 & 3 - by Ron Ramirez - 09-03-2012, 04:51 PM
RE: I've done it again, #2 & 3 - by y2kbruce - 09-03-2012, 05:24 PM
RE: I've done it again, #2 & 3 - by Ron Ramirez - 09-03-2012, 09:05 PM
RE: I've done it again, #2 & 3 - by rocketeer - 09-04-2012, 08:40 AM
RE: I've done it again, #2 & 3 - by Eliot Ness - 09-04-2012, 11:00 AM
RE: I've done it again, #2 & 3 - by y2kbruce - 09-04-2012, 07:21 PM
RE: I've done it again, #2 & 3 - by Ron Ramirez - 09-04-2012, 08:24 PM
RE: I've done it again, #2 & 3 - by Ron Ramirez - 09-06-2012, 05:43 AM
RE: I've done it again, #2 & 3 - by Eliot Ness - 09-06-2012, 09:46 AM
RE: I've done it again, #2 & 3 - by Doug Houston - 09-07-2012, 09:54 PM
RE: I've done it again, #2 & 3 - by Arran - 09-07-2012, 11:08 PM
RE: I've done it again, #2 & 3 - by TA Forbes - 09-08-2012, 01:24 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM

[-]
Who's Online
There are currently 5187 online users. [Complete List]
» 1 Member(s) | 5186 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)