Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

I've done it again, #2 & 3
#12

I recently saw Jim Clark at the hotel, at the MARC "extravaganza" meet. He'd been through stock car racing, and was in a crackup, and has been into some other endeavor.

He had wanted the vintage radio game to pay off big, and it never did. He's totally out of the radio game, so I understand.


Messages In This Thread
I've done it again, #2 & 3 - by Ron Ramirez - 09-03-2012, 04:45 PM
RE: I've done it again, #2 & 3 - by Ron Ramirez - 09-03-2012, 04:51 PM
RE: I've done it again, #2 & 3 - by y2kbruce - 09-03-2012, 05:24 PM
RE: I've done it again, #2 & 3 - by Ron Ramirez - 09-03-2012, 09:05 PM
RE: I've done it again, #2 & 3 - by rocketeer - 09-04-2012, 08:40 AM
RE: I've done it again, #2 & 3 - by Eliot Ness - 09-04-2012, 11:00 AM
RE: I've done it again, #2 & 3 - by y2kbruce - 09-04-2012, 07:21 PM
RE: I've done it again, #2 & 3 - by Ron Ramirez - 09-04-2012, 08:24 PM
RE: I've done it again, #2 & 3 - by Ron Ramirez - 09-06-2012, 05:43 AM
RE: I've done it again, #2 & 3 - by Eliot Ness - 09-06-2012, 09:46 AM
RE: I've done it again, #2 & 3 - by Doug Houston - 09-07-2012, 09:54 PM
RE: I've done it again, #2 & 3 - by Arran - 09-07-2012, 11:08 PM
RE: I've done it again, #2 & 3 - by TA Forbes - 09-08-2012, 01:24 AM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM

[-]
Who's Online
There are currently 4204 online users. [Complete List]
» 1 Member(s) | 4203 Guest(s)
Avatar

>