Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

38-15 Project
#7

I finally got time to get back on the project. I had the the new caps to replace #31 hooked up all wrong. Once I studied the schematic I was able to figure out how they needed to be hooked up.

I have the radio playing and it works very well pulls in stations good, and the shortwave is very sensitive. Also cleaned up the chassis, painted the power transformer bells, and shined up the IF can and old E-Cap shells.

The power transformer gets a little hot so I'm working on figuring out what value/wattage dropper resistor to put in line with the power cord. I tried a 50ohm/50W which seems to do good drops the input voltage from 125 to ~110.

Here is a couple pics.

[Image: http://i1129.photobucket.com/albums/m501...3486C9.jpg] [Image: http://i1129.photobucket.com/albums/m501...D0517B.jpg] [Image: http://i1129.photobucket.com/albums/m501...F35EBD.jpg]

I added an input for an MP3 player or phone to the back of the set.

Now to start on that cabinet.

-Keith


Messages In This Thread
38-15 Project - by ipwizard - 08-10-2012, 01:25 PM
RE: 38-15 Project - by Chuck Schwark - 08-10-2012, 01:32 PM
RE: 38-15 Project - by codefox1 - 08-10-2012, 02:02 PM
RE: 38-15 Project - by Chuck Schwark - 08-10-2012, 03:22 PM
RE: 38-15 Project - by ipwizard - 08-10-2012, 04:40 PM
RE: 38-15 Project - by ipwizard - 08-13-2012, 01:05 AM
RE: 38-15 Project - by ipwizard - 09-30-2012, 12:39 AM
RE: 38-15 Project - by Ron Ramirez - 09-30-2012, 06:42 AM
RE: 38-15 Project - by TA Forbes - 09-30-2012, 08:32 AM
RE: 38-15 Project - by ipwizard - 09-30-2012, 12:46 PM
RE: 38-15 Project - by Arran - 09-30-2012, 08:41 PM
RE: 38-15 Project - by ipwizard - 10-01-2012, 01:12 PM
RE: 38-15 Project - by Chuck Schwark - 10-01-2012, 03:56 PM
RE: 38-15 Project - by ipwizard - 10-01-2012, 06:32 PM
RE: 38-15 Project - by Chuck Schwark - 10-02-2012, 08:58 AM
RE: 38-15 Project - by Ron Ramirez - 10-02-2012, 09:03 AM
RE: 38-15 Project - by ipwizard - 10-02-2012, 02:13 PM
RE: 38-15 Project - by Ron Ramirez - 10-02-2012, 02:23 PM
RE: 38-15 Project - by codefox1 - 10-02-2012, 02:24 PM
RE: 38-15 Project - by TA Forbes - 10-02-2012, 04:14 PM
RE: 38-15 Project - by LASJayhawk - 10-02-2012, 09:53 PM
RE: 38-15 Project - by ipwizard - 10-03-2012, 12:14 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM

[-]
Who's Online
There are currently 5101 online users. [Complete List]
» 1 Member(s) | 5100 Guest(s)
Avatar

>