1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
38-15 Project
Ron Ramirez
Silent Key
*****
Posts: 13,776
Threads: 580
Joined: Sep 2005
City: Ferdinand State, Province, Country: Indiana
#18

10-02-2012, 02:23 PM
ipwizard Wrote:Would it be worth it to unhook the secondaries of the PT and see if it still gets hot with no load?

Yes!
--
Ron Ramirez
Ferdinand IN
Find
« Next Oldest | Next Newest »


Messages In This Thread
38-15 Project - by ipwizard - 08-10-2012, 01:25 PM
RE: 38-15 Project - by Chuck Schwark - 08-10-2012, 01:32 PM
RE: 38-15 Project - by codefox1 - 08-10-2012, 02:02 PM
RE: 38-15 Project - by Chuck Schwark - 08-10-2012, 03:22 PM
RE: 38-15 Project - by ipwizard - 08-10-2012, 04:40 PM
RE: 38-15 Project - by ipwizard - 08-13-2012, 01:05 AM
RE: 38-15 Project - by ipwizard - 09-30-2012, 12:39 AM
RE: 38-15 Project - by Ron Ramirez - 09-30-2012, 06:42 AM
RE: 38-15 Project - by TA Forbes - 09-30-2012, 08:32 AM
RE: 38-15 Project - by ipwizard - 09-30-2012, 12:46 PM
RE: 38-15 Project - by Arran - 09-30-2012, 08:41 PM
RE: 38-15 Project - by ipwizard - 10-01-2012, 01:12 PM
RE: 38-15 Project - by Chuck Schwark - 10-01-2012, 03:56 PM
RE: 38-15 Project - by ipwizard - 10-01-2012, 06:32 PM
RE: 38-15 Project - by Chuck Schwark - 10-02-2012, 08:58 AM
RE: 38-15 Project - by Ron Ramirez - 10-02-2012, 09:03 AM
RE: 38-15 Project - by ipwizard - 10-02-2012, 02:13 PM
RE: 38-15 Project - by Ron Ramirez - 10-02-2012, 02:23 PM
RE: 38-15 Project - by codefox1 - 10-02-2012, 02:24 PM
RE: 38-15 Project - by TA Forbes - 10-02-2012, 04:14 PM
RE: 38-15 Project - by LASJayhawk - 10-02-2012, 09:53 PM
RE: 38-15 Project - by ipwizard - 10-03-2012, 12:14 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM
Philco 42-390, code 121 speaker
>>A closer examination of the very small print schematic indicates that the speaker is a PM type. This shows a ...morzh — 05:18 PM
Philco 60 Squealing
Litz is typically tinned by simply rubbing it with the soldering iron tip while immersed in solder (and a bit of rosin f...morzh — 05:14 PM
Philco 6K7
The suppressor grid (if by G3 you mean the S) is usually at the Cathode potential, which in this caes is GND. I am not ...morzh — 05:10 PM
Philco 16B Parts
Thanks for the reply. Unfortunately the radio was removed before bidding was over so I didn't get a chance to bid.dconant — 04:10 PM
Philco 16B Parts
Hi Dan, Mike is correct, there's a lot of painted stuff on the chassis but it looks pretty good. The sm is all there,sp...Radioroslyn — 03:50 PM

[-]
Who's Online
There are currently 3854 online users. [Complete List]
» 1 Member(s) | 3853 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration