Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

A Beginner's Journey: The Philco 40-190

Deckape, is the hum level changed at all by increasing the volume? If not, perhaps a little cathode to filament leak on one of the tubes in the audio output. The voice coil, a possibility if the wires were switched. If it has a hum bucking coil tied to the voice coil and things are turned around, it won't cut some of the induced hum from the field coil they have to be in opposition. Just my lame ideas. Congrats on getting this far!
Jerry

A friend in need is a pest!  Bill Slee ca 1970.


Messages In This Thread
RE: A Beginner's Journey: The Philco 40-190 - by jerryhawthorne - 10-08-2012, 04:20 PM
[No subject] - by DeckApe - 07-07-2008, 03:39 PM
[No subject] - by Ron Ramirez - 07-07-2008, 09:45 PM
[No subject] - by DeckApe - 07-08-2008, 07:27 PM
[No subject] - by Michael Dennis - 07-08-2008, 10:14 PM
[No subject] - by DeckApe - 07-09-2008, 12:24 AM
[No subject] - by Michael Dennis - 07-09-2008, 07:05 AM
[No subject] - by DeckApe - 07-17-2008, 12:46 AM
[No subject] - by gary rabbitt - 07-17-2008, 03:04 AM
[No subject] - by DeckApe - 07-17-2008, 11:57 AM
[No subject] - by DeckApe - 07-18-2008, 11:28 PM
[No subject] - by DeckApe - 07-21-2008, 12:38 PM
[No subject] - by DeckApe - 07-24-2008, 11:17 PM
[No subject] - by DeckApe - 07-27-2008, 09:29 PM
[No subject] - by DeckApe - 07-29-2008, 01:16 AM
[No subject] - by BDM - 07-29-2008, 08:56 AM
[No subject] - by DeckApe - 07-29-2008, 12:20 PM
[No subject] - by DeckApe - 08-14-2008, 01:09 AM
[No subject] - by DeckApe - 08-14-2008, 11:48 AM
[No subject] - by Ron Ramirez - 08-14-2008, 10:37 PM
[No subject] - by DeckApe - 08-15-2008, 08:04 AM
[No subject] - by Ron Ramirez - 08-15-2008, 05:30 PM
[No subject] - by DeckApe - 08-16-2008, 03:38 PM
[No subject] - by Ron Ramirez - 08-16-2008, 04:17 PM
[No subject] - by DeckApe - 08-16-2008, 05:02 PM
[No subject] - by DeckApe - 08-21-2008, 01:08 AM
Re: - by Chuck Schwark - 09-07-2008, 10:49 PM
Re: A Beginner's Journey: The Philco 40-190 - by Guest - 09-16-2008, 08:30 PM
Re: A Beginner's Journey: The Philco 40-190 - by Guest - 03-28-2010, 04:08 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
My Philco 37-116 Restore
Are you measuring relative to the centertap or the GND?morzh — 11:57 PM
Philco 610B oscillator wiring
Still not clear on the wiring interface between the 6A7 and oscillator. After refering to the available schematics and s...Tubester — 07:18 PM
Refinishing Ideas
My 37-116 code 121 is the best sounding radio i have...a daily driver. Since we are talking about "changes". ...poulsbobill — 07:18 PM
My Philco 37-116 Restore
Hello, I finally got brave enough to take the cans off the Expander Unit. Got the grid cap wires replaced and back toget...dconant — 06:50 PM
Zenith H725
I got into the first AM IF can today, and found its mica was cracked. Amazing that it was still working. This one makes ...EdHolland — 06:10 PM
Philco model #20
AHH HA , I got it and can’t thank you fellows enough , when I changed the capacitors I took the advice and did not unsol...onlyrick — 02:24 PM
Zenith H725
Hello Ed, yes, I like letting projects run for few days to make sure they don't start acting up . Sincerely Richardradiorich — 01:03 PM
Philco 46-480 Electronic Restoration
I am almost finished with this restoration. All which remains is the power transformer. I cleaned it up some time ago, b...jrblasde — 12:41 PM
Philco model #20
I seem to recall in some TRF sets there being a Local/Distance toggle switch that removes the B+ from the first 24 rf tu...RodB — 09:46 AM
Refinishing Ideas
Hi Doppelganger, After rereading your thread, did you mount the Zenith speakers in the two bottom left and right pos...MrFixr55 — 09:39 AM

[-]
Who's Online
There are currently no members online.

>