Zenith 9-S-262 Alignment Questions

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Zenith 9-S-262 Alignment Questions

rghines1
Member

Posts: 190
Threads: 8
Joined: Oct 2005
City: Lexington, SC

10-24-2012, 04:58 PM

The 6L7 is the 1st Detector. Odd this is mistaken on the schematic as the 2nd Detector. Removed the grid cap wire on the 6L7 during the IF alignment, reconnect when complete.

Dummy antenna is kinda odd lingo and can have various meanings depending on context. Connect capacitors or 400 ohm resistor in series with the signal lead as called for on the procedure. You will be connecting to the antenna post.

Find

« Next Oldest | Next Newest »

Messages In This Thread

Zenith 9-S-262 Alignment Questions - by Geoff - 10-24-2012, 03:36 PM

RE: Zenith 9-S-262 Alignment Questions - by rghines1 - 10-24-2012, 04:58 PM

RE: Zenith 9-S-262 Alignment Questions - by Geoff - 10-24-2012, 06:16 PM

RE: Zenith 9-S-262 Alignment Questions - by Geoff - 10-24-2012, 08:27 PM

RE: Zenith 9-S-262 Alignment Questions - by rghines1 - 10-24-2012, 08:51 PM

RE: Zenith 9-S-262 Alignment Questions - by Geoff - 10-24-2012, 10:28 PM

RE: Zenith 9-S-262 Alignment Questions - by Ron Ramirez - 10-25-2012, 05:39 AM

RE: Zenith 9-S-262 Alignment Questions - by Geoff - 10-25-2012, 12:20 PM

RE: Zenith 9-S-262 Alignment Questions - by morzh - 10-25-2012, 08:33 PM

RE: Zenith 9-S-262 Alignment Questions - by codefox1 - 10-25-2012, 10:37 PM

RE: Zenith 9-S-262 Alignment Questions - by Geoff - 10-25-2012, 11:31 PM

RE: Zenith 9-S-262 Alignment Questions - by Geoff - 11-02-2012, 11:51 AM

RE: Zenith 9-S-262 Alignment Questions - by morzh - 11-02-2012, 06:37 PM

RE: Zenith 9-S-262 Alignment Questions - by Geoff - 11-02-2012, 07:00 PM

View a Printable Version

Users browsing this thread: 2 Guest(s)

Recent Posts
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached. I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM

Who's Online
There are currently no members online.

Login
Username:
Password:	Lost Password?
	Remember me