1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Zenith 9-S-262 Alignment Questions
Ron Ramirez
Silent Key
*****
Posts: 13,776
Threads: 580
Joined: Sep 2005
City: Ferdinand State, Province, Country: Indiana
#7

10-25-2012, 05:39 AM
No, what you have highlighted is the primary of the audio output transformer. To connect across the speaker voice coil, you would connect on the other side of the iron core - under where it says 13 on your drawing.
--
Ron Ramirez
Ferdinand IN
Find
« Next Oldest | Next Newest »


Messages In This Thread
Zenith 9-S-262 Alignment Questions - by Geoff - 10-24-2012, 03:36 PM
RE: Zenith 9-S-262 Alignment Questions - by Geoff - 10-24-2012, 06:16 PM
RE: Zenith 9-S-262 Alignment Questions - by Geoff - 10-24-2012, 08:27 PM
RE: Zenith 9-S-262 Alignment Questions - by Geoff - 10-24-2012, 10:28 PM
RE: Zenith 9-S-262 Alignment Questions - by Ron Ramirez - 10-25-2012, 05:39 AM
RE: Zenith 9-S-262 Alignment Questions - by Geoff - 10-25-2012, 12:20 PM
RE: Zenith 9-S-262 Alignment Questions - by morzh - 10-25-2012, 08:33 PM
RE: Zenith 9-S-262 Alignment Questions - by Geoff - 10-25-2012, 11:31 PM
RE: Zenith 9-S-262 Alignment Questions - by Geoff - 11-02-2012, 11:51 AM
RE: Zenith 9-S-262 Alignment Questions - by morzh - 11-02-2012, 06:37 PM
RE: Zenith 9-S-262 Alignment Questions - by Geoff - 11-02-2012, 07:00 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM

[-]
Who's Online
There are currently 6758 online users. [Complete List]
» 1 Member(s) | 6757 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)