Another 90 Question concerning grommets last post.

Thread Rating:

1 Vote(s) - 5 Average
1
2
3
4
5

Linear Mode

Another 90 Question concerning grommets last post.

TA Forbes
Deviate Emeritus

Posts: 2,353
Threads: 92
Joined: May 2010
City: Clayton, NC

10-26-2012, 11:17 PM

The single 47 model 90 only has two electrolytic caps, both are 6mFd. Never assume the "technician" that repaired your set did it the way it should have been done.

When you replace the two electrolytics, install your replacements so that they are as shown on the schematic.

I used 6.8mFd caps on my 90.

Find

« Next Oldest | Next Newest »

Messages In This Thread

Another 90 Question concerning grommets last post. - by jerryhawthorne - 10-26-2012, 09:20 PM

RE: Another 90 Question - by TA Forbes - 10-26-2012, 11:17 PM

RE: Another 90 Question - by jerryhawthorne - 10-27-2012, 01:45 AM

RE: Another 90 Question - by TA Forbes - 10-27-2012, 04:23 PM

RE: Another 90 Question - by jerryhawthorne - 10-27-2012, 10:06 PM

RE: Another 90 Question - by jerryhawthorne - 10-29-2012, 07:21 PM

RE: Another 90 Question now more with pictures - by Steve Davis - 10-29-2012, 08:36 PM

RE: Another 90 Question now more with pictures - by jerryhawthorne - 10-29-2012, 11:00 PM

RE: Another 90 Question now more with pictures - by jerryhawthorne - 11-16-2012, 06:33 PM

RE: Another 90 Question now more with pictures - by jerryhawthorne - 11-18-2012, 12:15 AM

RE: Another 90 Question now more with pictures - by jerryhawthorne - 11-18-2012, 07:22 PM

RE: Another 90 Question concerning grommets last post. - by Groundhog74 - 11-26-2012, 10:49 AM

RE: Another 90 Question concerning grommets last post. - by jerryhawthorne - 11-26-2012, 01:57 PM

RE: Another 90 Question concerning grommets last post. - by Ron Ramirez - 11-26-2012, 07:54 PM

RE: Another 90 Question concerning grommets last post. - by jerryhawthorne - 11-26-2012, 08:08 PM

RE: Another 90 Question concerning grommets last post. - by TA Forbes - 11-26-2012, 11:15 PM

View a Printable Version

Users browsing this thread: 11 Guest(s)

Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

Who's Online
There are currently no members online.

Login
Username:
Password:	Lost Password?
	Remember me