1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Dial Pointer & String Philco 40-150
BOB C.
Junior Member
**
Posts: 11
Threads: 4
Joined: Mar 2007
#2

07-23-2007, 08:44 PM
Just wondering if you ever found the part you were looking for. I just picked up a 40-150 my self with the exact same problem. I also need the indicator or pointer as well as a diagram for restringing. Thanks for your reply. Bob
Robert Chesarek
Renfrew, PA
Find
« Next Oldest | Next Newest »


Messages In This Thread
Dial Pointer & String Philco 40-150 - by Guest - 11-13-2006, 10:13 PM
[No subject] - by BOB C. - 07-23-2007, 08:44 PM
[No subject] - by Guest - 07-23-2007, 09:30 PM
[No subject] - by Guest - 07-23-2007, 09:41 PM
[No subject] - by BOB C. - 07-23-2007, 10:41 PM
[No subject] - by Chuck Schwark - 07-23-2007, 10:52 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM
Philco 42-390, code 121 speaker
>>A closer examination of the very small print schematic indicates that the speaker is a PM type. This shows a ...morzh — 05:18 PM
Philco 60 Squealing
Litz is typically tinned by simply rubbing it with the soldering iron tip while immersed in solder (and a bit of rosin f...morzh — 05:14 PM
Philco 6K7
The suppressor grid (if by G3 you mean the S) is usually at the Cathode potential, which in this caes is GND. I am not ...morzh — 05:10 PM
Philco 16B Parts
Thanks for the reply. Unfortunately the radio was removed before bidding was over so I didn't get a chance to bid.dconant — 04:10 PM

[-]
Who's Online
There are currently 4853 online users. [Complete List]
» 4 Member(s) | 4849 Guest(s)
AvatarAvatarAvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration