Another 90 Question concerning grommets last post.

Thread Rating:

1 Vote(s) - 5 Average
1
2
3
4
5

Linear Mode

Another 90 Question concerning grommets last post.

jerryhawthorne
Phorum Expert

Posts: 1,562
Threads: 56
Joined: Nov 2008
City: Sedona, AZ/Placentia/CA

#13

11-26-2012, 01:57 PM

Thanks for the information. In looking at mine I would say your correct that the thicker side of the grommet is on the bottom side of the chassis. They don't look like a lot of fun to replace! Which ever way sets the tuner height proper should work.

Jerry

A friend in need is a pest! Bill Slee ca 1970.

Find

« Next Oldest | Next Newest »

Messages In This Thread

Another 90 Question concerning grommets last post. - by jerryhawthorne - 10-26-2012, 09:20 PM

RE: Another 90 Question - by TA Forbes - 10-26-2012, 11:17 PM

RE: Another 90 Question - by jerryhawthorne - 10-27-2012, 01:45 AM

RE: Another 90 Question - by TA Forbes - 10-27-2012, 04:23 PM

RE: Another 90 Question - by jerryhawthorne - 10-27-2012, 10:06 PM

RE: Another 90 Question - by jerryhawthorne - 10-29-2012, 07:21 PM

RE: Another 90 Question now more with pictures - by Steve Davis - 10-29-2012, 08:36 PM

RE: Another 90 Question now more with pictures - by jerryhawthorne - 10-29-2012, 11:00 PM

RE: Another 90 Question now more with pictures - by jerryhawthorne - 11-16-2012, 06:33 PM

RE: Another 90 Question now more with pictures - by jerryhawthorne - 11-18-2012, 12:15 AM

RE: Another 90 Question now more with pictures - by jerryhawthorne - 11-18-2012, 07:22 PM

RE: Another 90 Question concerning grommets last post. - by Groundhog74 - 11-26-2012, 10:49 AM

RE: Another 90 Question concerning grommets last post. - by jerryhawthorne - 11-26-2012, 01:57 PM

RE: Another 90 Question concerning grommets last post. - by Ron Ramirez - 11-26-2012, 07:54 PM

RE: Another 90 Question concerning grommets last post. - by jerryhawthorne - 11-26-2012, 08:08 PM

RE: Another 90 Question concerning grommets last post. - by TA Forbes - 11-26-2012, 11:15 PM

View a Printable Version

Users browsing this thread: 5 Guest(s)

Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

Who's Online
There are currently no members online.

Login
Username:
Password:	Lost Password?
	Remember me