Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

38-15 finished
#7

Really nice job. Raising the bar for all!


Messages In This Thread
38-15 finished - by ipwizard - 11-30-2012, 11:37 PM
RE: 38-15 finished - by Dave D - 12-01-2012, 12:05 AM
RE: 38-15 finished - by chris25260880 - 12-01-2012, 02:14 AM
RE: 38-15 finished - by Paul Philco322 - 12-01-2012, 09:19 PM
RE: 38-15 finished - by Glenn Roberts - 12-01-2012, 09:41 PM
RE: 38-15 finished - by ipwizard - 12-02-2012, 08:15 PM
RE: 38-15 finished - by codefox1 - 12-02-2012, 09:45 PM
RE: 38-15 finished - by Tom Hamilton - 12-03-2012, 10:45 PM
RE: 38-15 finished - by TA Forbes - 12-03-2012, 11:06 PM
RE: 38-15 finished - by jerryhawthorne - 12-04-2012, 08:19 PM
RE: 38-15 finished - by fixinmyphilco - 12-04-2012, 08:56 PM
RE: 38-15 finished - by FStephenMasek - 12-05-2012, 01:29 AM
RE: 38-15 finished - by ipwizard - 12-05-2012, 01:39 PM



Users browsing this thread: 5 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM
Model 28L
Hello, I'm restoring a Philco 28L and the output transformer is open. Part number of the transformer is 32-7020. Can...HORSTE — 10:32 AM

[-]
Who's Online
There are currently 3832 online users. [Complete List]
» 1 Member(s) | 3831 Guest(s)
Avatar

>