42-1008 code 122

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

42-1008 code 122

Eric T
Senior Member

Posts: 298
Threads: 22
Joined: May 2012
City: Chattanooga State, Province, Country: TN

#29

12-28-2012, 06:08 PM

Sorry, I should have been more specific.

I have a 95 volt rough sawtooth shaped 60 hz waveform at the plate of the 7C6. There is no signal at the control grid for the 7C6.

Input filter cap (76) is connected as specified, positive to one of the 5Y4G filaments at the left side of the field coil and negative to the HV secondary center tap left side of 146 ohm resistor.

(This post was last modified: 12-28-2012, 06:39 PM by Eric T.)

Find

« Next Oldest | Next Newest »

Messages In This Thread

42-1008 code 122 - by Eric T - 12-26-2010, 02:49 PM

RE: 42-1008 code 122 - by Eric T - 06-05-2012, 08:02 PM

RE: 42-1008 code 122 - by Michael Dennis - 06-05-2012, 08:20 PM

RE: 42-1008 code 122 - by Sean - 06-06-2012, 11:24 AM

RE: 42-1008 code 122 - by Eric T - 06-06-2012, 06:21 PM

RE: 42-1008 code 122 - by Eric T - 07-18-2012, 10:12 PM

RE: 42-1008 code 122 - by Eric T - 07-29-2012, 09:58 AM

RE: 42-1008 code 122 - by Eric T - 07-29-2012, 10:07 AM

RE: 42-1008 code 122 - by Eric T - 12-16-2012, 09:57 AM

RE: 42-1008 code 122 - by Eric T - 12-20-2012, 10:05 PM

RE: 42-1008 code 122 - by Eric T - 12-22-2012, 01:28 PM

RE: 42-1008 code 122 - by Eric T - 12-22-2012, 05:14 PM

RE: 42-1008 code 122 - by Ron Ramirez - 12-23-2012, 12:09 PM

RE: 42-1008 code 122 - by Eric T - 12-23-2012, 03:27 PM

RE: 42-1008 code 122 - by Eric T - 12-23-2012, 08:25 PM

RE: 42-1008 code 122 - by Eric T - 12-24-2012, 12:15 AM

RE: 42-1008 code 122 - by Eric T - 12-24-2012, 06:23 PM

RE: 42-1008 code 122 - by Eric T - 12-24-2012, 06:52 PM

RE: 42-1008 code 122 - by Ron Ramirez - 12-24-2012, 07:02 PM

RE: 42-1008 code 122 - by Eric T - 12-27-2012, 10:56 AM

RE: 42-1008 code 122 - by codefox1 - 12-27-2012, 04:36 PM

RE: 42-1008 code 122 - by Michael Dennis - 12-28-2012, 02:24 AM

RE: 42-1008 code 122 - by Eric T - 12-28-2012, 12:06 PM

RE: 42-1008 code 122 - by Eric T - 12-28-2012, 01:01 PM

RE: 42-1008 code 122 - by Eric T - 12-28-2012, 04:48 PM

RE: 42-1008 code 122 - by Ron Ramirez - 12-28-2012, 05:12 PM

RE: 42-1008 code 122 - by Ron Ramirez - 12-28-2012, 05:14 PM

RE: 42-1008 code 122 - by Eric T - 12-28-2012, 06:08 PM

RE: 42-1008 code 122 - by Eric T - 12-28-2012, 07:05 PM

RE: 42-1008 code 122 - by Ron Ramirez - 12-28-2012, 08:19 PM

RE: 42-1008 code 122 - by Eric T - 12-28-2012, 09:21 PM

RE: 42-1008 code 122 - by Eric T - 12-29-2012, 04:40 PM

RE: 42-1008 code 122 - by Eric T - 12-31-2012, 06:35 PM

RE: 42-1008 code 122 - by Eric T - 01-18-2013, 07:36 PM

RE: 42-1008 code 122 - by 7estatdef - 01-21-2013, 11:19 AM

RE: 42-1008 code 122 - by Eric T - 01-21-2013, 01:46 PM

RE: 42-1008 code 122 - by Eric T - 06-29-2013, 06:53 PM

RE: 42-1008 code 122 - by morzh - 06-29-2013, 10:02 PM

RE: 42-1008 code 122 - by Eric T - 06-30-2013, 05:39 PM

RE: 42-1008 code 122 - by morzh - 06-30-2013, 05:49 PM

RE: 42-1008 code 122 - by Eric T - 09-16-2013, 01:26 PM

RE: 42-1008 code 122 - by Eforrester - 11-22-2017, 11:52 PM

RE: 42-1008 code 122 - by Radioroslyn - 11-23-2017, 11:58 AM

RE: 42-1008 code 122 - by Eforrester - 11-30-2017, 12:38 PM

Re: 42-1008 code 122 - by 7estatdef - 12-26-2010, 04:07 PM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
trying to identify this wire type
Thanks to all for the feedback. As Arran said, it is probably an older replacement and yes it has a grid cap so I will ...georgetownjohn — 09:32 PM
trying to identify this wire type
It's possible that the red wire, actually a grid cap lead, is a very old replacement, I can't remember seeing a pre 1939...Arran — 09:18 PM
Gilfillan Brothers Car Radio?
Hi everyone, Special thanks to Joe Rossi for tracking down this obscure radio and thanks to others who took up the hun...Antipodal — 08:15 PM
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached. I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM

Who's Online
There are currently no members online.

Login
Username:
Password:	Lost Password?
	Remember me