Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

model 625 tone control problem
#5

Check to make sure the coupling cap to the center tap on the volume control has a value of about 0.01 ufd, not higher. Make sure all the bypass caps from high voltage points to chassis are present. very often, increasing the value of some of them from .05 or 0.1 ufd to 0.22 ufd solves the problem and has no negative impact at all on function. if you have not replaced the low value caps in the AGC block (about 120-150 uufd, do so.


Messages In This Thread
model 625 tone control problem - by Guest - 08-20-2007, 10:46 AM
[No subject] - by Ron Ramirez - 08-20-2007, 04:33 PM
[No subject] - by Guest - 08-21-2007, 12:26 PM
[No subject] - by Texasrocker - 08-21-2007, 08:13 PM
[No subject] - by radiomikee - 08-22-2007, 09:06 AM
[No subject] - by davemc - 10-01-2007, 07:32 AM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Samlex heavy-Duty bench supply filter question
Hello Everyone, I have one of my Heavy-duty bench powersuplies made by Samlex it's 13.8 volt dc 20-25 amp supply. What I...radiorich — 11:24 PM
Looking for place to donate unique Philco Philco J-1930 Prototype
It's a Glaser Sears changer which Philco's engineers thought was an upgrade over a VM, but in retrospect I'd prefer the ...jeibner — 10:39 PM
AC/DC Transformer-less Sets
Joseph, Thank you for the confirmation. I knew that there must be more to the Transformer-less AC/DC radios than the ...PeterN — 10:30 PM
AC/DC Transformer-less Sets
Good evening, folks. Power station engineer here! The east coast had pockets of DC-only power well into the twentieth...jrblasde — 10:11 PM
AC/DC Transformer-less Sets
Model 40 does not have a rectifier, so it would be a DC only model. This however does not say anything about using...morzh — 08:01 PM
AC/DC Transformer-less Sets
I was wondering if anyone knows if these AC/DC transformer-less sets were actually used on 110v DC anywhere, and when. ...PeterN — 06:35 PM
Looking for place to donate unique Philco Philco J-1930 Prototype
Given the 1960s vintage, it is likely that the cartridge is ceramic, likely more stable. The changer looks like a Voice...MrFixr55 — 05:03 PM
Jackson 665 j2 schematic request
FIXED!daveone23 — 03:55 PM
Bakelite crack repair - what is best epoxy?
Thanks everyone. I appreciate you sharing your experience and looks like I'll work with the 24 hr two part clear epoxy....de371 — 10:25 PM
Jackson 665 j2 schematic request
Without a schematic its going to be hard tracing the wire wound spool resistors.daveone23 — 05:21 PM

[-]
Who's Online
There are currently 5241 online users. [Complete List]
» 2 Member(s) | 5239 Guest(s)
AvatarAvatar

>