46-1201 ouestions about recap work

Thread Rating:

diyahnih
Junior Member

Posts: 20
Threads: 8
Joined: Jun 2007

09-06-2007, 01:15 AM

Ron,

the changes.zip & 461201.zip pages doesn't display in either my firefox or IE6 browsers--are they still there? The pages won't load.

diyahnih

Find

« Next Oldest | Next Newest »

Messages In This Thread

[No subject] - by Texasrocker - 09-05-2007, 11:38 PM

[No subject] - by Ron Ramirez - 09-06-2007, 12:12 AM

page won't display - by diyahnih - 09-06-2007, 01:15 AM

[No subject] - by Texasrocker - 09-06-2007, 02:07 AM

thanks texasrocker - by diyahnih - 09-06-2007, 02:15 AM

[No subject] - by Ron Ramirez - 09-06-2007, 07:00 AM

[No subject] - by Texasrocker - 09-07-2007, 09:43 PM

Users browsing this thread: 1 Guest(s)

Recent Posts
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone, As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic. This radio had a 8" Zenith speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM
Philco 42-390, code 121 speaker
>>A closer examination of the very small print schematic indicates that the speaker is a PM type. This shows a ...morzh — 05:18 PM
Philco 60 Squealing
Litz is typically tinned by simply rubbing it with the soldering iron tip while immersed in solder (and a bit of rosin f...morzh — 05:14 PM

Who's Online

There are currently 5085 online users. [Complete List]
» 1 Member(s) | 5084 Guest(s)