Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Getting a Philco 70 tomorrow
#5

           

Well I picked it up this morning. it is mostly intact. The grill and right side of the arch is loosing the veneer. It is hard to see, but the veneer on the arch is split in the middle. I am wondering the best way to approach this- just try to re-glue what is there (my first plan) or try to replace all the veneer on the right arch if I can't get it to look right.

Does anyone know what type walnut veneer it is? The lines are straight throughout it.

Steve


Messages In This Thread
Getting a Philco 70 tomorrow - by SteveJB - 01-15-2013, 11:20 PM
RE: Getting a Philco 70 tomorrow - by TA Forbes - 01-15-2013, 11:23 PM
RE: Getting a Philco 70 tomorrow - by Ron Ramirez - 01-16-2013, 06:28 AM
RE: Getting a Philco 70 tomorrow - by TA Forbes - 01-16-2013, 03:04 PM
RE: Getting a Philco 70 tomorrow - by SteveJB - 01-17-2013, 08:24 PM
RE: Getting a Philco 70 tomorrow - by Arran - 01-17-2013, 08:49 PM
RE: Getting a Philco 70 tomorrow - by SteveJB - 01-18-2013, 08:57 PM
RE: Getting a Philco 70 tomorrow - by Steve Davis - 01-18-2013, 10:07 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 42-345 Restoration/Repair
The 2 towns you mentioned "Frustrated" and "Give Up" are places we have all been. Relax, take 5, thi...Paul Philco322 — 03:23 PM
Philco 89 Code 123 Osc Coil
Thanks for posting that information!klondike98 — 03:14 PM
Philco 42-345 Restoration/Repair
From what I see is the blue cap was added by someone after the radio was sold presumably to replace cap 40A. I can't tel...RodB — 03:12 PM
Philco 42-345 Restoration/Repair
Correction My original picture shows #40 cap, blue cap and #42 resistor connected.osanders0311 — 02:23 PM
Philco 42-345 Restoration/Repair
Well guys I am stuck, frustrated and about ready to give up. For starters all I'm getting from the speaker is a humming ...osanders0311 — 02:17 PM
[split] New member...
Thanks.  I'll try that.HowardWoodard — 01:13 PM
[split] New member...
You may have to start further back with your signal injection at the IF signal grid, then tune the second IF transformer...RodB — 10:28 AM
[split] New member...
Well, with the replacement tuning assembly, I have finally put the unit back together and aligned the dial.  The first s...HowardWoodard — 01:01 AM
Philco Model 16 wiring question
Well, finding a short is easy. Like I said, disconnect the transformer's secondary windings and see if it persists. If...morzh — 09:48 PM
Restoring Philco 96
Nice one!Stan the Man — 09:37 PM

[-]
Who's Online
There are currently no members online.

>