Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 49-902
#3

Jerry,
Thanks for the reply and the advice! I have absolutely no experience with radios, however, I am a fast learner and I have a desire to learn. I have such a huge appreciation for older things (furniture, art, jewelry, etc.) I would much rather have something passed down to me than go out and buy something...it just means more to me that way. I have been reading up on repairing the radio myself and that is as far as my knowledge goes radio wise. I have a small amount of experience with soldering, but once again I am not afraid to get my hands dirty and figure things out.

I did read that even with the radio unplugged it still holds a charge, so I am a bit fearful of getting zapped. Besides that, I am still researching repairs through a few websites and getting familiar with the schematic.

V/R
Editha


Messages In This Thread
Philco 49-902 - by ebutler - 01-24-2013, 12:15 AM
RE: Philco 49-902 - by jerryhawthorne - 01-24-2013, 11:03 PM
RE: Philco 49-902 - by ebutler - 01-25-2013, 01:46 AM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM
Hickok AC51 tube tester
Note that no power cord, power switch, or power transformer switch are shown. That (along with my experience with full s...DaleHCook — 07:09 AM
IF can wire size and Rubber mounts?
A pair of wire strippers can give you an idea of what the existing gauge of the wire leads are in the IF can, I think it...Arran — 06:07 AM
My last cabinet for this year
Hello Dan, That is really beautiful what great looking radio you have ! I have friends who live in Calgary and the wea...radiorich — 01:51 AM

[-]
Who's Online
There are currently 4502 online users. [Complete List]
» 3 Member(s) | 4499 Guest(s)
AvatarAvatarAvatar

>