Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 38-116 Question More Questions
#18

Thanks Phlog and to you Brenda. And yes, the discriminator circuit looks much like those of FM receivers. Pholg when you say that no tone is necessary, should I just turn it off on the sig gen tone? If so, if I have a VOM on the speaker, well, don't know what will come out but willing to try. Brenda, your a bright light here and appreciate your help and knowledge. I'm wallowing in a lack of knowledge on this circuit. I have not figured out where item 97 on the schematic is on the radio. Seems it may have a part to do with the mag tuning.
http://www.nostalgiaair.org/PagesByModel...013235.pdf

Jerry

Edit: Phlog as far as I can see the mag switch consists of a single switch (small rotary) combined to another switch on the back to change the "flood lights" on when the switch is turned to mag tuning. I replaced the switch as the old one had a broken up switch for the lights on the back of it. New switch seems to work well for both the rotary part and the lights.

A friend in need is a pest!  Bill Slee ca 1970.


Messages In This Thread
RE: Philco 38-116 Question - by jerryhawthorne - 01-26-2013, 07:17 PM
RE: Philco 38-116 Question - by Phlogiston - 01-26-2013, 08:30 PM
RE: Philco 38-116 Question - by Ron Ramirez - 01-26-2013, 09:44 PM
RE: Philco 38-116 Question - by jerryhawthorne - 01-26-2013, 10:12 PM
RE: Philco 38-116 Question - by jerryhawthorne - 01-26-2013, 10:34 PM
RE: Philco 38-116 Question - by jerryhawthorne - 01-29-2013, 12:03 AM
RE: Philco 38-116 Question - by Phlogiston - 01-29-2013, 04:16 AM
RE: Philco 38-116 Question - by jerryhawthorne - 01-29-2013, 02:16 PM
RE: Philco 38-116 Question - by jerryhawthorne - 01-31-2013, 09:16 PM
RE: Philco 38-116 Question - by Phlogiston - 01-31-2013, 11:04 PM
RE: Philco 38-116 Question - by jerryhawthorne - 02-01-2013, 12:10 AM
RE: Philco 38-116 Question - by Phlogiston - 02-01-2013, 03:34 AM
RE: Philco 38-116 Question More Questions - by jerryhawthorne - 02-03-2013, 01:58 AM



Users browsing this thread: 5 Guest(s)
[-]
Recent Posts
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Hi Cap'n Clock, Unfortunately, I do not have this radio.  This is a shame because this should be a good performer.  2A5...MrFixr55 — 06:48 AM
American Bosch Model 802 auto radio
I think it would come under either American Bosch or United American Bosch. American Bosch made sets for the American We...Arran — 05:53 AM
trying to identify this wire type
Thanks to all for the feedback. As Arran said, it is probably an older replacement and yes it has a grid cap so I will ...georgetownjohn — 09:32 PM
trying to identify this wire type
It's possible that the red wire, actually a grid cap lead, is a very old replacement, I can't remember seeing a pre 1939...Arran — 09:18 PM
Gilfillan Brothers Car Radio?
Hi everyone,  Special thanks to Joe Rossi for tracking down this obscure radio and thanks to others who took up the hun...Antipodal — 08:15 PM
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM

[-]
Who's Online
There are currently no members online.

>