1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
No grid voltage in model 20
Danny
Member
***
Posts: 64
Threads: 22
Joined: Oct 2006
City: Acworth State, Province, Country: GA
#1

10-01-2007, 09:15 PM
1st and 2nd RF has no voltage on grid. Coils #2 and #7 are not open, primary or secondary. No issues with volume control and I've replaced all caps including filters and all resistors. A bit lost here. Can anyone give me a hint as to where to look next ? I'm done for the night but will look into forum tomorrow morning while at work. Thanks in advanced. Icon_cry Here is link to schematic.
http://www.philcoradio.com/tech/images/20a.jpg
Danny
Find
« Next Oldest | Next Newest »


Messages In This Thread
No grid voltage in model 20 - by Danny - 10-01-2007, 09:15 PM
[No subject] - by rickd - 10-02-2007, 09:43 AM
[No subject] - by Danny - 10-02-2007, 11:23 AM
[No subject] - by rickd - 10-02-2007, 11:15 PM
[No subject] - by Danny - 10-14-2007, 02:15 PM
[No subject] - by rickd - 10-17-2007, 04:53 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco Model 80 Transformer resistance
Just forget this number, it is useless anyway. Simply proceed with your project.morzh — 10:08 PM
Philco Model 80 Transformer resistance
My $0.02 is that it is a misprint. I tried to look up the value for the similar 84 and 37-84, and ther is no resistance...MrFixr55 — 09:51 PM
Philco Model 80 Transformer resistance
Thanks for the quick reply! Hmm...well that's good, so what am I seeing that's 1042 ohms on the schematic for the pow...Mike L — 08:46 PM
Philco Model 80 Transformer resistance
The DC resistance of the primary is 8 to 9 Ohm.morzh — 07:54 PM
Philco Model 80 Transformer resistance
I have a feeling the primary winding on the power transformer is bad. My resistance reading on the primary side is 9 ohm...Mike L — 07:48 PM
Rusty Tuning Condenser
I would try Naval Jelly and use a soaked pipe cleaner to get it where it needs to go.RossH — 06:56 PM
38-10T chassis Restoration begins
Hello Dconant , they sold mica to use as a insulator between transistors and their heatsinks too. Rob I will remove th...radiorich — 02:52 PM
38-10T chassis Restoration begins
Thanks for the info guys. I always wondered why the use of mica. Now I know.dconant — 01:52 PM
38-10T chassis Restoration begins
Most common plastics have a dielectric constant in the 3-4 range whereas mica is around 6. This means that even if you w...Steve D — 01:46 PM
38-10T chassis Restoration begins
It is acceptable but not desirable. Plastic is not an approved cap dielectric, and even though a reasonably thick piece...morzh — 11:52 AM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration