Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 1 Vote(s) - 3 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Production Numbers vs. Model Numbers
#6

I had a fellow collector friend in Alberta that thought you could figure out how rare or common something was based on how high the serial number was. The trouble with that is how do you know what number they started with in the first place? How do you know that maybe the low serial number wasn't just the result of your radio being from an early production run. As for sharing cabinets among models Canadian Westinghouse used to be notorious for that, one set that I have is a five tube AC model but they had a seven tube farm set that used the same cabinet, the same is true of the Westinghouse used in "A Christmas Story" they used a few different chassis in that cabinet and in other cabinets.
Regards
Arran


Messages In This Thread
RE: Production Numbers vs. Model Numbers - by Arran - 02-09-2013, 12:17 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
[split] New member...
Well, with the replacement tuning assembly, I have finally put the unit back together and aligned the dial.  The first s...HowardWoodard — 01:01 AM
Philco Model 16 wiring question
Well, finding a short is easy. Like I said, disconnect the transformer's secondary windings and see if it persists. If...morzh — 09:48 PM
Restoring Philco 96
Nice one!Stan the Man — 09:37 PM
Restoring Philco 96
I have eventually replaced the speaker and shot the video, which only shows the upper part of the dial as the hum is ver...morzh — 09:24 PM
Rogers Majestic R-646
Kinda weird to see both open Nothing weird if you remember that this radio is about 100 years old  :)Vlad95 — 07:49 PM
Philco 42-345 Restoration/Repair
I believe I'm making progress, resistors have been rechecked and corrected, removed that ugly blue capacitor and more wi...osanders0311 — 07:38 PM
Philco Model 16 wiring question
Thanks Morzh Yes I recapped everything and replaced almost all the resistors as well. I redid #99 with .015 safety ca...bobclausen — 07:11 PM
Philco Model 16 wiring question
Well...pull out every single load of the transformer. For every winding. Unsolder if needed. Then re-do your dim bulb....morzh — 07:02 PM
Rogers Majestic R-646
Kinda weird to see both open, but once you get it up and running, really pay attention to your sound. Listen for loud cr...TV MAN — 06:59 PM
Rogers Majestic R-646
Vlad; I was just reminded of something else, I'm not sure why but many Rogers built sets do seem to have open primari...Arran — 04:40 PM

[-]
Who's Online
There are currently 1027 online users. [Complete List]
» 1 Member(s) | 1026 Guest(s)
Avatar

>