Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

My 60L before and after.
#7

The friend who repaired mine said he saw a stamp on the chassis or original speaker that said '1934'. If that is true mine was probably produced early that year. It's just nice to have it back together again and I do still have the original speaker with hopes of having it reconed someday. It was ripped to shreds.

No matter where you go, there you are.


Messages In This Thread
My 60L before and after. - by Jayce - 02-10-2013, 09:28 PM
RE: My 60L before and after. - by Jayce - 02-11-2013, 12:47 PM
RE: My 60L before and after. - by 7estatdef - 02-11-2013, 01:08 PM
RE: My 60L before and after. - by Jayce - 02-11-2013, 05:47 PM
RE: My 60L before and after. - by Bob Andersen - 02-11-2013, 06:38 PM
RE: My 60L before and after. - by Ron Ramirez - 02-11-2013, 07:17 PM
RE: My 60L before and after. - by Jayce - 02-11-2013, 10:19 PM
RE: My 60L before and after. - by Jayce - 02-13-2013, 04:37 PM
RE: My 60L before and after. - by Paul Philco322 - 02-13-2013, 10:50 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently no members online.

>