Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 40-150
#3

Nice set. I have a 40-180 console, which I believe uses the same chassis. At one time I had a 40-150 as well, but sold it about 15 years ago. I now have the 1939 slant front table model 39-30 instead, mainly because I really like that back lit white dial face they used that year only. What part of Wisconsin are you located? I'm in West Bend. As for decals, you probably already know, www.radiodaze.com is the place to go. I believe they also have the wine colored reproduction pushbuttons as well. Perhaps Ron can point you to the exact decal sheet that's correct for this set. Good luck... should be a fun restoration project. Let's hope this current freezing & snowy Wisconsin weather leads to an early spring!

Greg V.
West Bend, WI
Member WARCI.org


Messages In This Thread
Philco 40-150 - by 37silverstreak - 02-17-2013, 02:16 PM
RE: Philco 40-150 - by Electrothaumaturgist - 02-17-2013, 03:49 PM
RE: Philco 40-150 - by NostalgiaRadioTime - 02-17-2013, 03:52 PM
RE: Philco 40-150 - by jontz - 02-17-2013, 08:03 PM
RE: Philco 40-150 - by 37silverstreak - 02-17-2013, 08:59 PM
RE: Philco 40-150 - by Paul Philco322 - 02-17-2013, 09:11 PM



Users browsing this thread:
[-]
Recent Posts
Philco 42-345 Restoration/Repair
The 2 towns you mentioned "Frustrated" and "Give Up" are places we have all been. Relax, take 5, thi...Paul Philco322 — 03:23 PM
Philco 89 Code 123 Osc Coil
Thanks for posting that information!klondike98 — 03:14 PM
Philco 42-345 Restoration/Repair
From what I see is the blue cap was added by someone after the radio was sold presumably to replace cap 40A. I can't tel...RodB — 03:12 PM
Philco 42-345 Restoration/Repair
Correction My original picture shows #40 cap, blue cap and #42 resistor connected.osanders0311 — 02:23 PM
Philco 42-345 Restoration/Repair
Well guys I am stuck, frustrated and about ready to give up. For starters all I'm getting from the speaker is a humming ...osanders0311 — 02:17 PM
[split] New member...
Thanks.  I'll try that.HowardWoodard — 01:13 PM
[split] New member...
You may have to start further back with your signal injection at the IF signal grid, then tune the second IF transformer...RodB — 10:28 AM
[split] New member...
Well, with the replacement tuning assembly, I have finally put the unit back together and aligned the dial.  The first s...HowardWoodard — 01:01 AM
Philco Model 16 wiring question
Well, finding a short is easy. Like I said, disconnect the transformer's secondary windings and see if it persists. If...morzh — 09:48 PM
Restoring Philco 96
Nice one!Stan the Man — 09:37 PM

[-]
Who's Online
There are currently 1078 online users. [Complete List]
» 1 Member(s) | 1077 Guest(s)
Avatar

>