1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Home Radios
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
I finally got one!
Jayce
Phorum Expert
*****
Posts: 2,026
Threads: 367
Joined: Jun 2010
City: Dover, OH
#3

02-25-2013, 08:57 PM
Thanks, Ron. The photofinish is what first caught my eye on this unit when I saw it sitting on a high shelf in the former owner's back room roughly a year ago. I carefully got it down and after a bit of dusting I was able to see it still had a nearly perfect photofinish with just a bit of normal wear around the volume knob.
No matter where you go, there you are.
Find
« Next Oldest | Next Newest »


Messages In This Thread
I finally got one! - by Jayce - 02-25-2013, 06:22 PM
RE: I finally got one! - by Ron Ramirez - 02-25-2013, 08:09 PM
RE: I finally got one! - by Jayce - 02-25-2013, 08:57 PM
RE: I finally got one! - by TA Forbes - 02-26-2013, 01:00 PM
RE: I finally got one! - by Jayce - 02-26-2013, 04:47 PM
RE: I finally got one! - by TA Forbes - 02-26-2013, 08:00 PM
RE: I finally got one! - by Art Hoch - 02-27-2013, 08:44 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM
Model 28L
Hello, I'm restoring a Philco 28L and the output transformer is open. Part number of the transformer is 32-7020. Can...HORSTE — 10:32 AM

[-]
Who's Online
There are currently 6451 online users. [Complete List]
» 2 Member(s) | 6449 Guest(s)
AvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Home Radios