Philco model 18 (code 121) - HELP!
Posts: 1,562
Threads: 56
Joined: Nov 2008
City: Sedona, AZ/Placentia/CA
Yes Plith, some radios (early) don't go above 1500. Hard to tell from your video but you have to have the signal from your sig gen hooked up right. The high side to the antenna and the ground on the radio chassis. Modulator turned on. Just set the sig generator somewhere on the middle of the AM dial and scan your radio to see if you can find that sweet and annoying tone. If no joy, you may not have the oscillator on your radio working. Glad to see you passed the first test.
Jerry
A friend in need is a pest! Bill Slee ca 1970.
Messages In This Thread
RE: Philco model 18 (code 121) - HELP! - by jerryhawthorne - 02-26-2013, 11:03 PM
Users browsing this thread: 31 Guest(s)
|
Recent Posts
|
Philco 16B Parts
|
The 16B's in the tombstone cabinet sport a 10 1/2" spkr vs the older cathedral sets which uses an 8". The p/p ...Radioroslyn — 12:58 AM |
Philco 38-7 Oscillation
|
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 11:16 PM |
Philco 38-7 Speaker
|
I know that when I first started working on this radio, I did not even have a speaker. Once I finally found one it was n...tludka — 11:00 PM |
Philco 60 Squealing
|
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM |
Philco 42-390, code 121 speaker
|
These speakers pop up on eBay regularly, even if at bloated prices.
Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM |
Philco 38-7 Speaker
|
The put-put is not like the speaker problem.morzh — 08:29 PM |
Mission Bell Model 19A Car Radio
|
Hello everyone,
As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM |
Philco 60 Squealing
|
Wondering if I did it backwards.
If a coil was wound backwards, the oscillator would not work at all.
Old school...Chas — 07:23 PM |
Philco 38-7 Speaker
|
4-ohm speaker. Black, Green leads.tludka — 07:00 PM |
Philco 42-390, code 121 speaker
|
#87 on the schematic.
This radio had a 8" Zenith speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM |
Who's Online
|
There are currently no members online. |
|
|