Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12, 2025) x

Thread Closed

Admiral 5D3A
#2

Well the low volume issue is probably a bad phono cartridge. It could be a out of spec plate resistor on the 12AT/V6 but I doubt it. They are somewhat hard to find. This set more than likely uses one with two needles one for the 78's and the other for 45's and LP's. Make sure that you use the proper needle for the record you are playing. It may have an adjmt for the tracking weigh. This sets how much pressure the tip of the needle presses onto the record. Too much will cause premature wear to the record. This adjmt is located at the far end of the tone arm. Modern Records?????
Terry


Messages In This Thread
Admiral 5D3A - by Eric T - 03-02-2013, 08:20 PM
RE: Admiral 5D3A - by 7estatdef - 03-03-2013, 01:19 PM
RE: Admiral 5D3A - by codefox1 - 03-03-2013, 02:01 PM
RE: Admiral 5D3A - by 7estatdef - 03-03-2013, 02:23 PM
RE: Admiral 5D3A - by Eric T - 03-05-2013, 10:07 AM
RE: Admiral 5D3A - by Eric T - 03-07-2013, 07:59 PM
RE: Admiral 5D3A - by Eric T - 03-08-2013, 08:55 PM
RE: Admiral 5D3A - by codefox1 - 03-08-2013, 09:54 PM
RE: Admiral 5D3A - by Eric T - 03-09-2013, 03:02 PM
RE: Admiral 5D3A - by Eric T - 03-14-2013, 05:44 PM
RE: Admiral 5D3A - by codefox1 - 03-15-2013, 01:15 AM
RE: Admiral 5D3A - by Eric T - 05-16-2013, 08:08 PM
RE: Admiral 5D3A - by BrendaAnnD - 05-16-2013, 08:33 PM
RE: Admiral 5D3A - by GarySP - 05-16-2013, 10:08 PM
RE: Admiral 5D3A - by Eric T - 05-16-2013, 11:41 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
54C Complete Teardown/Rebuild
Hello Roy, here is this one sincerely Richardradiorich — 12:45 AM
54C Complete Teardown/Rebuild
Richard, Had grabbed it already but thank you just the same.  I find myself wanting to find some way to block out the...glyphmon — 12:03 AM
54C Complete Teardown/Rebuild
Hello roy, here is a link to the schematic . Sincerely Richardradiorich — 11:54 PM
54C Complete Teardown/Rebuild
Richard, The Silvertone 2014 also is a transformerless set, so I am incorporating a 1:1 600 ohm audio isolation transfo...glyphmon — 11:37 PM
Preliminary work on wife's Silvertone 2014
Did an alignment today which was interesting.  IF alignment went great, almost all was already spot-on.  Adjusting on th...glyphmon — 11:35 PM
54C Complete Teardown/Rebuild
The main problem with adding a Bluetooth input is that this set lacks a traditional power transformer to isolate it from...radiorich — 11:19 PM
54C Cabinet Refinish
I started stripping this cabinet before it got super chilly out because I knew I wasn't going to be able to work on ...glyphmon — 11:18 PM
54C Complete Teardown/Rebuild
While I'm waiting to wrap up the final steps on my wife's Silvertone 2014, I started disassembly on the next project.  O...glyphmon — 11:07 PM
Preliminary work on wife's Silvertone 2014
Hello roy, that great news glad it worked out for you !! Sincerely Richardradiorich — 10:50 PM
Preliminary work on wife's Silvertone 2014
Safety caps arrived today.  Soldered one in and had a successful first power-up.  No magic smoke escaped and it tunes in...glyphmon — 09:53 PM

[-]
Who's Online
There are currently no members online.

>