Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

The Philco Radio Story on Video
#8

I've got an 87 and a 95 with that cabinet too.
Terry


Messages In This Thread
The Philco Radio Story on Video - by Ron Ramirez - 03-09-2013, 10:10 PM
RE: The Philco Radio Story on Video - by Jayce - 03-09-2013, 10:18 PM
RE: The Philco Radio Story on Video - by Art Hoch - 03-09-2013, 11:12 PM
RE: The Philco Radio Story on Video - by Arran - 03-10-2013, 01:21 AM
RE: The Philco Radio Story on Video - by w4rtc - 03-10-2013, 01:43 AM
RE: The Philco Radio Story on Video - by 7estatdef - 03-10-2013, 02:22 PM
RE: The Philco Radio Story on Video - by Dave D - 03-11-2013, 10:53 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM

[-]
Who's Online
There are currently 6305 online users. [Complete List]
» 2 Member(s) | 6303 Guest(s)
AvatarAvatar

>