Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

My Philco 38-116
#3

Very nice, I just finished a chassis for a friend. I can never figure out why, when replacing the e-caps people seem to like to remove and discard the old caps leaving a hole in the the chassis? Had the same problem on my friends and was lucky and found some duds to fill the holes.
Nice performing radio.
Jerry

A friend in need is a pest!  Bill Slee ca 1970.


Messages In This Thread
My Philco 38-116 - by Jayce - 03-11-2013, 12:31 PM
RE: My Philco 38-116 - by Jayce - 03-11-2013, 12:38 PM
RE: My Philco 38-116 - by jerryhawthorne - 03-11-2013, 01:15 PM
RE: My Philco 38-116 - by Ron Ramirez - 03-11-2013, 04:16 PM
RE: My Philco 38-116 - by Art Hoch - 03-11-2013, 05:19 PM
RE: My Philco 38-116 - by Jayce - 03-11-2013, 10:40 PM
RE: My Philco 38-116 - by Jayce - 03-12-2013, 01:11 AM
RE: My Philco 38-116 - by Gene Pederson - 03-12-2013, 05:54 PM
RE: My Philco 38-116 - by Jayce - 03-12-2013, 09:25 PM
RE: My Philco 38-116 - by jerryhawthorne - 03-12-2013, 10:08 PM
RE: My Philco 38-116 - by Jayce - 03-12-2013, 11:29 PM
RE: My Philco 38-116 - by jerryhawthorne - 03-13-2013, 12:13 AM
RE: My Philco 38-116 - by jerryhawthorne - 03-17-2013, 02:40 PM
RE: My Philco 38-116 - by Jayce - 03-17-2013, 05:07 PM
RE: My Philco 38-116 - by Arran - 03-18-2013, 08:36 PM
RE: My Philco 38-116 - by jerryhawthorne - 03-19-2013, 08:04 PM
RE: My Philco 38-116 - by Jayce - 03-19-2013, 09:18 PM



Users browsing this thread: 5 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM
Model 28L
Hello, I'm restoring a Philco 28L and the output transformer is open. Part number of the transformer is 32-7020. Can...HORSTE — 10:32 AM

[-]
Who's Online
There are currently no members online.

>