1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Home Radios
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
PHILCO 98 EXPORT Model
Ron Ramirez
Silent Key
*****
Posts: 13,776
Threads: 580
Joined: Sep 2005
City: Ferdinand State, Province, Country: Indiana
#16

03-17-2013, 01:08 PM
Willie / Hotwire

I just sent an email to you with a PDF file; this contains the 640 service bulletin plus all known production changes. Hope this helps.

I still need to look for a wave trap. I am sure I have one or three around here somewhere.
--
Ron Ramirez
Ferdinand IN
Find
« Next Oldest | Next Newest »


Messages In This Thread
PHILCO 98 EXPORT Model - by HOTWIRE - 10-08-2012, 01:50 PM
RE: PHILCO 98 EXPORT Model - by TA Forbes - 10-08-2012, 10:33 PM
RE: PHILCO 98 EXPORT Model - by HOTWIRE - 10-13-2012, 09:44 AM
RE: PHILCO 98 EXPORT Model - by HOTWIRE - 10-13-2012, 09:53 AM
RE: PHILCO 98 EXPORT Model - by TA Forbes - 10-14-2012, 08:55 AM
RE: PHILCO 98 EXPORT Model - by Ron Ramirez - 10-14-2012, 09:17 AM
RE: PHILCO 98 EXPORT Model - by Ron Ramirez - 10-14-2012, 11:01 AM
RE: PHILCO 98 EXPORT Model - by TA Forbes - 10-14-2012, 09:26 PM
RE: PHILCO 98 EXPORT Model - by Arran - 10-14-2012, 11:02 PM
RE: PHILCO 98 EXPORT Model - by HOTWIRE - 10-15-2012, 03:18 PM
RE: PHILCO 98 EXPORT Model - by Ron Ramirez - 10-15-2012, 04:23 PM
RE: PHILCO 98 EXPORT Model - by HOTWIRE - 10-15-2012, 07:18 PM
RE: PHILCO 98 EXPORT Model - by HOTWIRE - 03-12-2013, 11:27 AM
RE: PHILCO 98 EXPORT Model - by Ron Ramirez - 03-15-2013, 02:04 PM
RE: PHILCO 98 EXPORT Model - by HOTWIRE - 03-15-2013, 11:14 PM
RE: PHILCO 98 EXPORT Model - by Ron Ramirez - 03-17-2013, 01:08 PM
RE: PHILCO 98 EXPORT Model - by HOTWIRE - 03-19-2013, 09:09 AM
RE: PHILCO 98 EXPORT Model - by HOTWIRE - 09-09-2014, 06:02 PM
RE: PHILCO 98 EXPORT Model - by HOTWIRE - 09-09-2014, 06:06 PM
RE: PHILCO 98 EXPORT Model - by HOTWIRE - 09-09-2014, 06:13 PM
RE: PHILCO 98 EXPORT Model - by Ron Ramirez - 09-09-2014, 06:47 PM
RE: PHILCO 98 EXPORT Model - by HOTWIRE - 09-09-2014, 08:19 PM



Users browsing this thread: 13 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Home Radios