Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

It's Alive!!!
#19

I don't see any solution here other then to try finding a 60 cycle replacement for this changer, that may take some time. The only real way to see if the motor is working properly is to find someone with a VFD (variable frequency drive) to test it with, but everything that I have read and heard is that an AC motor should run faster at a higher line frequency not slower. There were pockets of 25 cycle service in the U.S, most notably in upper New York state around Niagara Falls, I think there were some in Pennsylvania as well, so it isn't a uniquely Canadian thing. In fact much of Canada was always on 60 Cycle power, like in Quebec and the Prairie provinces.
Regards
Arran


Messages In This Thread
It's Alive!!! - by Mr Grumpy - 02-11-2013, 04:28 PM
RE: It's Alive!!! - by klondike98 - 02-11-2013, 05:09 PM
RE: It's Alive!!! - by Mr Grumpy - 02-12-2013, 01:21 PM
RE: It's Alive!!! - by jerryhawthorne - 02-12-2013, 01:35 PM
RE: It's Alive!!! - by marv - 02-12-2013, 04:37 PM
RE: It's Alive!!! - by jerryhawthorne - 02-12-2013, 05:58 PM
RE: It's Alive!!! - by Mr Grumpy - 02-13-2013, 12:23 AM
RE: It's Alive!!! - by Eric T - 02-14-2013, 10:20 PM
RE: It's Alive!!! - by jerryhawthorne - 02-14-2013, 10:31 PM
RE: It's Alive!!! - by wa2ise - 02-14-2013, 11:50 PM
RE: It's Alive!!! - by TA Forbes - 02-15-2013, 01:24 AM
RE: It's Alive!!! - by Mr Grumpy - 02-16-2013, 09:49 PM
RE: It's Alive!!! - by Mr Grumpy - 02-27-2013, 01:09 PM
RE: It's Alive!!! - by Mr Grumpy - 03-20-2013, 09:48 PM
RE: It's Alive!!! - by 7estatdef - 03-22-2013, 09:47 PM
RE: It's Alive!!! - by Mr Grumpy - 03-22-2013, 10:58 PM
RE: It's Alive!!! - by Arran - 03-22-2013, 11:18 PM
RE: It's Alive!!! - by Mr Grumpy - 03-22-2013, 11:55 PM
RE: It's Alive!!! - by Arran - 03-23-2013, 03:18 AM
RE: It's Alive!!! - by Steve Davis - 03-23-2013, 02:27 PM
RE: It's Alive!!! - by 7estatdef - 03-23-2013, 06:19 PM
RE: It's Alive!!! - by Mr Grumpy - 03-23-2013, 10:01 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
trying to identify this wire type
Thanks to all for the feedback. As Arran said, it is probably an older replacement and yes it has a grid cap so I will ...georgetownjohn — 09:32 PM
trying to identify this wire type
It's possible that the red wire, actually a grid cap lead, is a very old replacement, I can't remember seeing a pre 1939...Arran — 09:18 PM
Gilfillan Brothers Car Radio?
Hi everyone,  Special thanks to Joe Rossi for tracking down this obscure radio and thanks to others who took up the hun...Antipodal — 08:15 PM
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM

[-]
Who's Online
There are currently 5736 online users. [Complete List]
» 2 Member(s) | 5734 Guest(s)
AvatarAvatar

>